Slot Modification

402blownstroker

[H]ard|DCer of the Month - Nov. 2012
Joined
Jan 5, 2006
Messages
3,257
What is the safest way to remove the back part of a slot to allow a longer card to be placed into it? For example, putting a 16x card into a 8x physical slot.
 
I would use a dremel with the flex attachment, but you could probably use a small file or something.

I've actually seen some motherboards recently that just came with the slot already cut like that.
 
I would use a dremel with the flex attachment, but you could probably use a small file or something.

I've actually seen some motherboards recently that just came with the slot already cut like that.

The right angle attachment is an even better way to cut stuff like that.
 
I didn't know there was a right angle attachment, but yeah, if there is, that and a cutoff wheel should make this easy.

Just don't nick the board itself.
 
I would use a dremel with the flex attachment, but you could probably use a small file or something.

I've actually seen some motherboards recently that just came with the slot already cut like that.

Speaking of which, if a modern mobo doesn't do that, watch out for clearance. There may be something that impinges on it behind the slot.
 
a hot knife or oscillating multi-tool. a dremel can leave conductive dust/residue

I was planning on using a dremel and blowing the slot out with an air compressor. Would that be good enough or would moe cleanup be needed?
 
is a riser not an option?

This used to be popular over at bitcointalk for miners before risers were readily available/cheap/stable.

example here, a few posts in OP says he used an exacto knife
 
I used a thin-tipped solder iron to open up my x1 mining risers. Just need a steady hand and the right iron and it's easy as pie. I would expect the same with your board slots.
 
Back
Top