AFD
2[H]4U
- Joined
- Aug 7, 2013
- Messages
- 2,154
Here are some patterns I made using the available tooling
I see, thanks. Wasn't sure if the holes/slots were being punched, drilled, or whatnot.
For some reason, rectangle #2, and then rounded rectangle #3 look best to my eyes.. def prefer the finished rows (flush ends). Rounded #1 could be made flush using the hole punch from the current M1 in place of the very last slots (hole in each corner), and would look very nice.
Not sure, but I would think offset slots would be less prone to getting bent out of shape than say rectangle #1.