Hi all
So I have nearly completed a new build using 2x 360mm (45mm thick) rads..
My loop is pump to gpu.. then into first rad. Out of first rad into motherboard VRM’s, then into processor, then into second rad and back into reservoir..
Does this seem ok or would I face any issues with this...
Hi all
Having an issue with icue not seeing my motherboard or corsair ram sticks. Fans I can control ok though.. is there an easy way to check a few things to get this sorted? Anyone else have similar issues with icue ?
Whole RGB process seems a bit of a nightmare from my first impression
Hi all
So nearly finished my build (Maximus formula DDR5) however I’ve noticed my RAM is at 4900 mhz, the kit I’ve bought is 5600 mhz.. is this something to do with the bios ?
Thanks for all the replies
All seems ok-ish… got a loop going on the processor only for now, temp stayed at 30degrees C in the bios, although the chipset was showing 60degrees C in the bios… loaded windows 11 and the Corsair icue software (not the easiest I must say), on the monitor tab I’m...
No no, pump was not connected at all..I should have it piped up in the next couple days, just a simple loop to the cpu so I can get windows installed and sort out the lighting.. possibly next week I’ll have a GPU in the loop too 😊
This is the stage I’m at
Hi all
So I very stupidly put a system together with said processor and a rog maximus formula motherboard.. installed some M.2 ssd’s, got some fans linked up, memory in, psu in… I flicked it all on to check the mother board lighted up and stuff a few times for maybe 45 seconds - 1min, I did this...