Recent content by DytrdrB

Already tried replacing the battery. That did not work. I have never actually flashed BIOS before (I have only used 3rd party apps to do it) so I don't know exactly how. Anyways, I tried to create a DOS boot disk so that I could flash the BIOS but for some reason none of my diskettes are any...

I am putting together a new system. however when I try to boot up I get the "cmos checksum error". This occurs even with default settings. When i try to change the cd drive to the first boot device I save and exit but I get a message on screen that says no video signal and I have to reset the...

for the slaved drive it is 27.92 GB FAT 32 Healthy (active)

I tried that and the only options that I can use are "delete partion" and "help", the others are dimmed and I can't select them.

In the disk manager it does not show a name where the other disk has a name (c: ). I mean in the "volume" column. It says disk 1 in the graphical view though. When I ran "cmd" then used the command it says the drive or path is not valid. I typed " "chkdsk 1" then tried "chkdsk disk1" and...

Yes it is partitioned. But when I do "chkdisk DRIVELETTER" the command prompt seems to appear for a split second and then is gone. Also, the drive is not given a letter it is given a number.

It shows that I have the drive connected to my computer

I need to access the data on a drive that runs windows 98. I tried to set the drive as a slave to my computer that runs XP. I can see the drive when I go into my cmos but I can't see the drive when I boot up. Is this because the drives have different OS's? How can I fix this. Also, can I...

If you put dual channel memory in a board that doesn't support dual channel will the memory still work? Also, I don't know what 2t or 1t means. All I know is that you use 2t when you fill all four mem slots on a board. Is this correct? What does it mean? Do you have to configure the board in...

I am new to OC'ing so I just needed some opinions. Thanks. Any other significantly different comments are still welcome. :D

At 2.9ghz it runs load @ 40C. I have a Zalman 7000B CU.

I can run my Opteron 148 @ 2.7ghz @ 1.36v (stock). Howvever, I can get to 2.9ghz @ 1.5v. Actually, I set the voltage to 1.525 but it reads with smartguardian and cpuz as 1.5v. It also performs load at 40C. What does anyone here think. Is the extra .14v - .165v worth the extra .2ghz?

The DFI LP UT nF4 Ultra-D can be modded for SLI, that is if you know how to. However, the DFI LP UT nF4 SLI-D is supposed to be comprable to the Ultra-D except already ready for SLI. That is what I would go for. Also, the board is not the only thing that can determine your OC. The major factor...

Well I think I found the BIOS I was looking for. Thanx