OK ive posted a few posts about this here already, but I cant seem to find anything that works.
I recently built a new computer.
Albatron KM18G Pro motherboard (which has a GeForce 4 MX onboard video)
Seagate 80Gb HDD
AMD Duron 1.8Ghz
512Mb Corsair DDR RAM
I ordered a video card, a Gigabyte GA-R9200 128mb DDr, and it hasnt come in yet, so it isnt the comp.
Whenever I open a video file, the file will run for around 10-15 seconds, but have flickers on it, and then it will BSOD. It will say either
"BAD_POOL_CALLER"
"PAGE_FAULT_IN_NONPAGED_AREA"
"IRQL_NOT_LESS_OR_EQUAL"
or it will give a BSOD with a win2k.sys error
My old comp screwed up, because I put a dvd drive without the top on it on the open computer and it static'd all the shit inside there. I have the burner from the old comp in the new comp, and that works fine, and I put the old HDD as a slave and retrieved as much as I could off there, but when I got into it it would restart as I was trying to retrieve certain files.
And also, when I try to open some install files (like winxp service pack 1) , or a prog to make the 6 XP boot disks, it says "Cannot open file. Files corrupt " or osmething like that, on both of them.
What could be the problem? I ran memtest86 about 4 times through and it came up with no errors, and I ran chkdsk and it couldnt find any errors at all
Please I hope somebody could help, this is really annoying
I recently built a new computer.
Albatron KM18G Pro motherboard (which has a GeForce 4 MX onboard video)
Seagate 80Gb HDD
AMD Duron 1.8Ghz
512Mb Corsair DDR RAM
I ordered a video card, a Gigabyte GA-R9200 128mb DDr, and it hasnt come in yet, so it isnt the comp.
Whenever I open a video file, the file will run for around 10-15 seconds, but have flickers on it, and then it will BSOD. It will say either
"BAD_POOL_CALLER"
"PAGE_FAULT_IN_NONPAGED_AREA"
"IRQL_NOT_LESS_OR_EQUAL"
or it will give a BSOD with a win2k.sys error
My old comp screwed up, because I put a dvd drive without the top on it on the open computer and it static'd all the shit inside there. I have the burner from the old comp in the new comp, and that works fine, and I put the old HDD as a slave and retrieved as much as I could off there, but when I got into it it would restart as I was trying to retrieve certain files.
And also, when I try to open some install files (like winxp service pack 1) , or a prog to make the 6 XP boot disks, it says "Cannot open file. Files corrupt " or osmething like that, on both of them.
What could be the problem? I ran memtest86 about 4 times through and it came up with no errors, and I ran chkdsk and it couldnt find any errors at all
Please I hope somebody could help, this is really annoying