PLEASE help, new computer setup problem.

Finder

n00b
Joined
Jun 29, 2007
Messages
4
I hope this is the right forum to ask this, if not, could a mod please move it to the proper location.


I recently did a major upgrade to my computer, basically it's a new computer in the old case.

Components:
EVGA 640 8800GTS R
(x2 SLI Config)

MEM 2GB OCZ HIGH PERFOMANCE DDR2 (Purchased 4GB, RMAing one set due to a bad stick)

Motherboard VGA 122-CK-NF68-A1 N680i SLI R

PSU Thermaltake 700W

CPU INTEL E6600 2.4G 775

OS: Windows Vista Ultimate

-Latest drivers for everything.
-Latest Windows updates
-Latest BIOS, default settings
-No Overclocking or tweaking of anything
-Power set on seperate rails to the max extent possible

Now my problem:
While installing new software the computer pauses for long periods of time (up to several minutes or longer) and appears to be doing nothing, no HD activity. I can't seem to do anything during these pauses, although the mouse or computer doesn't completely lock up. I also sometimes get pauses when just starting software. Other times the computer just seems much slower than it should be. I've installed temperature monitoring software and temps are good. They are a little bit high, but well within spec on cpu and graphics cards. It's driving me nuts...Every time I use this computer it just doesn't seem "right"

Any help or suggestions would be greatly appreciated...It's driving me insane. If you need any more info just ask.

Thanks in advance.
 
keep task manager open and sort by cpu priority and watch whats going on in your pc's brain. that happens on my computer here at work, and I usually have to end up closing and dozen different virus scanners that open themselves every couple of hours.

also, nice system. please tell me you'll be overclocking :)

edit: to clarify, use the PC normally *with* task manager open. you can see whats happening as the hangs occur.
 
I've done clean installs and this still happens before I've installed my antivirus. For what it's worth though, I'm using Live Onecare.
 
Don't install nTune.

Make sure you RAM is getting enough voltage -- default it 1.80 or 1.85, I don't remember which, but the RAM is likely designed to run at 2.1v or thereabout. Also turn off SLI ready memory and Nvidia GPU Ex, force memory timings yourself. All the SLI-ready stuff is useless if you know what you're doing and is just another potential source of problems.

Give vcore a small bump and see if that helps -- vdroop can actually leave you running the CPU at below spec vcore by default.

Try a different version of Forceware, even if it's older. I've had good luck with 106.03, but have since moved on. As you said this happened during install I doubt it's a driver issue, though.
 
Back
Top