Moogle Stiltzkin
Gawd
- Joined
- Nov 11, 2004
- Messages
- 814
Hi, i need some help to figure out whether i did my calibration correctly seeing as i am a newbie
The results
I reset to factory settings which were all 50 before i ran the calibration process. I followed the software instructions and set the following below to meet the target.
red 18
green 23
blue 50
brightness 22
Did i do this correctly I was using the X-rite Eye one display 2 calibrator on a Dell 2405 FPW lcd monitor with the Basic Color software instead of the Eye Match software.
Is it correct that blue is showing high in the charts ? When i was calibrating i left the blue as the default 50 as this was what someone suggested i do, and i only adjusted red and green to meet the target as follows.
6500 lumi
220
2.2 gamma
Any thoughts ? Yes i made just my monitor was warmed up for an hour or more. Also background lighting was turned off. I also set to factory before i started to calibrate.
The results
I reset to factory settings which were all 50 before i ran the calibration process. I followed the software instructions and set the following below to meet the target.
red 18
green 23
blue 50
brightness 22
Did i do this correctly I was using the X-rite Eye one display 2 calibrator on a Dell 2405 FPW lcd monitor with the Basic Color software instead of the Eye Match software.
Is it correct that blue is showing high in the charts ? When i was calibrating i left the blue as the default 50 as this was what someone suggested i do, and i only adjusted red and green to meet the target as follows.
6500 lumi
220
2.2 gamma
Any thoughts ? Yes i made just my monitor was warmed up for an hour or more. Also background lighting was turned off. I also set to factory before i started to calibrate.