Need some Help please!

tree_

[H]ard|Gawd
Joined
Jun 22, 2004
Messages
1,707
So I went with a bit of an upgrade from my Socket 754 Athlon64 3200+ to a Athlon64 Socket 939 3700+ today.

On my old Athlon64 3200+ I had taken the CPU out to redo the thermal paste and when reinstalling I somehow broke off 2 PINS on the CPU so when I tried to run the computer all lights would turn on but the power button would not turn it on or off, had to use the switch in the back, and I would get no video what so ever. So I figured this would be due to the 2 broke pins no big deal, shame on me breaking the pins.

So today I go to hookup my Athlon64 Socket 939 3700+ and my MSI K8N Neo2 Platinum motherboard (parts I got used here) and I get the exact SAME problem. I have to use the switch in the back to get it to turn on. Once on, all the lights and fins spin up as normal but I get NO picture and my power button doesn't do a thing. Now I was very careful and patient when putting these parts in so I know I installed them correctly

First I thought ok, maybe my X800XTPE videocard went bad for some reason so I throw in my Nvidia 6600GT and I get the same exact thing, no video to my moniter. I turn my moniter on and it just goes to standby mode.

If anyone could help me with suggestions on what to try I would GREATLY appreciate it. I have no idea where to start or what to try. Could it be a bad PSU? I thought if Motherboard, Ram, or CPU was bad it would't even power up...

Please help!
Thanks,
tree_
 
does the board beep without any ram installed? did you try only one stick of ram? in different slots? do the fans spin at all? did you try another psu?
 
Have you tried reassembling the PC outside of the case? Sometimes cases can short out the mobo, therefore you won't see any video.
 
Also check to make sure you have the 20 pin PSU connector pluged in the the 24 pin motherboard correctly.
 
Back
Top