Hi,
I bought these waterblocks:
For CPU GPU SR Water Cooling Heatsink Block Liquid Cooler Aluminium Waterblock
I know they are junk but I needed a lot of them and could not afford the good ones.
I am planning to use it to cool a load up to 130W.
It is too big for the application so I will have to glue using thermal epoxy an aluminum plate just a bit smaller on the bottom of it.
The plate is 2.3mm thick.
The waterblock has been anodized blue.
Will that interfere with the heat transfer and/or the gluing?
Should I lap the wb and what grit paper do you recommend?
Thanks!
I bought these waterblocks:
For CPU GPU SR Water Cooling Heatsink Block Liquid Cooler Aluminium Waterblock
I know they are junk but I needed a lot of them and could not afford the good ones.
I am planning to use it to cool a load up to 130W.
It is too big for the application so I will have to glue using thermal epoxy an aluminum plate just a bit smaller on the bottom of it.
The plate is 2.3mm thick.
The waterblock has been anodized blue.
Will that interfere with the heat transfer and/or the gluing?
Should I lap the wb and what grit paper do you recommend?
Thanks!
Last edited:
As an eBay Associate, HardForum may earn from qualifying purchases.