OSEProphecy
Limp Gawd
- Joined
- Jan 2, 2003
- Messages
- 146
Like the title says, aiming for a 1 ghz oc on a q6600 . I want to do this on air cooling, system is in sig. I'm just having a little trouble cause this is my first OC attempt on a gigabyte board and the settings are a little strange to me.( always used asus before this) I am at 3 ghz right now.
mem is generic 2 gig from xps 720 and 2 gigs corsair value. running at 416mhz. I Have already got 4 gigs of OCZ Reaper HPC (Part# OCZ2RPR10664GK) on the way.
Current Settings :
Robust Graphics Booster ( What is this?) is set to turbo
Clock ratio 9x
CPU Host Freq 333
PCI Express Freq 100
CIA2 Disabled
Preformance enhance Disabled
System memory multiplier 2.5 (memory divider from asus?)
All Dram settings to Auto ( will enter all the correct settings once new ram is recieved)
The only voltage not on auto is CPU VCORE and that is at 1.40000. This was the lowest I could set to get 3ghz to run Prime stable for several hours.
I have not changed any of the other settings because I cannot tell what they are! the only option is normal or the + 0.05V. this is frustrating because I don't know where it is starting I have Loadline calibration off.
I want another 400mhz out of this thing but don't want to push much further right now cause the ram is rated at 666mhz and I am already pushing 832 (again new ram on the way) so in a day or 2 this won't be an issue. Temps right now are 31c to 34c idle and 51c to 55c at full load under prime95. Are these good tems? My proc is GO stepping and according to intel can operate at up 71c. I read Greysky awsome overclocing guide but due to gigabytes wierd sttings not sure where to start to go further voltage wise. Any help is appreciated.
mem is generic 2 gig from xps 720 and 2 gigs corsair value. running at 416mhz. I Have already got 4 gigs of OCZ Reaper HPC (Part# OCZ2RPR10664GK) on the way.
Current Settings :
Robust Graphics Booster ( What is this?) is set to turbo
Clock ratio 9x
CPU Host Freq 333
PCI Express Freq 100
CIA2 Disabled
Preformance enhance Disabled
System memory multiplier 2.5 (memory divider from asus?)
All Dram settings to Auto ( will enter all the correct settings once new ram is recieved)
The only voltage not on auto is CPU VCORE and that is at 1.40000. This was the lowest I could set to get 3ghz to run Prime stable for several hours.
I have not changed any of the other settings because I cannot tell what they are! the only option is normal or the + 0.05V. this is frustrating because I don't know where it is starting I have Loadline calibration off.
I want another 400mhz out of this thing but don't want to push much further right now cause the ram is rated at 666mhz and I am already pushing 832 (again new ram on the way) so in a day or 2 this won't be an issue. Temps right now are 31c to 34c idle and 51c to 55c at full load under prime95. Are these good tems? My proc is GO stepping and according to intel can operate at up 71c. I read Greysky awsome overclocing guide but due to gigabytes wierd sttings not sure where to start to go further voltage wise. Any help is appreciated.