Search results

Swapped in a 7970 DCII for my 6990 yesterday to power my 5x1P setup. Very happy to see the back of crossfire. My only issue now is I can't increase the volts on this card at all. Idles at 1.09v and under load drops to 1.06 to 1.03v depending on the load put on it (as measured with GPU-Z and...

Available at http://downloads.guru3d.com/AMD-Catalyst-12.1-Preview-Driver-32-64-bit-driver-download-2826.html Major new feature is application profiles built in. Finally AMD has done this. Going to try them out now to see what Skyrim performance is like. EDIT: still no quad-fire in Skyrim :(...

Just grabbed myself an Asus 6950 Directcu II 2gb card (non reference, triple slot). This is a great card, runs cool, and so far I have it at 950/1375 at 1.21v. My problem is the card can only have its voltage increased with the bundled Asus Smartdoctor software (afterburner has the voltage...

Has anyone tried the 5970 on a PCI-e 1.0 x16 board? Just wondering what the performance would be like compared to a PCI-e 2.0 board given that the 2 GPUs share the 16x lane anyway. Would using 1.0 significantly reduce performance especially if you were gaming at eyefinity resolutions such as...

Hi Is this possible? All I have in the bios is the Game Accelerator Technology (GAT) settings. Disabling what I can there (having settings of auto-auto-auto-disabled-disabled) still leaves PAT enabled. Is there anything I can do to disable PAT on this board? Thanks

I have the system in sig, with a 2.8E C0 rev currently at 3.4ghz. I have just gone through the process of reseating my sp-94 using arctic ceramique. I made sure to do this very carefully following the ceramique instructions very closely. However I'm not experiencing any real temp drops. Abit...

Hi I have a thermalright sp-94 HSF applied with arctic ceramique to my 2.8e in sig. I'm getting ridiculous temps however. I'm at 3.4ghz now and during games I'm well into the 70s C. Idle is high 50s. The outside temp gets to no more than 25C and I have a well ventilated case (thermaltake...

Hi people Just wondering if there are any real dangers in having 2 hdds stacked on top of each other, hdd health reports the bottom drive as 38C and the top one as 27C, my other 2 hdds (spaced apart) are 16C each. In terms of the health of the stacked hdds, should I be worried about any...

Hi all I've searched around a little without any luck and was just wondering if I need to enable dual channel ddr or is it already enabled? My rig is in the sig below, i have two sticks of ddr400 ram, 1x512mb and 1x256mb. When i post theres no mention of "dual channel ddr enabled" or...