Recent content by THE DOME

No way I would pay that much for that, look at the tubing. Even if you have a huge radiator the pump is too slow and the tubing too small to pump the water at a rate fast enough to cool effeciently, you can put your own kit together that cools alot better and uses better components.

Yea, and when not in SLi 4 moniter's is possible, so if your looking for a cheaper solution you could do 2 6600Gt's if not gaming.

Just wait to upgrade, don't spend the money for all that just to have to get new stuff later.

Hydro L35 which is 450GPH.

I was under the impression that more fluid helped cool better. In that case I'll just get another 3 port res. and tap my fillport into it.

Will one 5.25" lucite bay res. be enough for the cpu block, two videocard blocks, chipset block and two 120MM radiators?

Alright the NV68's it is, that card keeper is a good idea, thanks guys.

Only problem is if it leaks you screwed, Nasa uses liquid metal for something, I can't remember what though.

For my upcoming rebuild I'm going to be using two eVGA 7800GT's. Now I was planning on taking off my low-profile DD maze 4 gpu on 6800gt and using that, then I rembered the NV68's. My question is, is the ram cooling really needed, and will two of these blocks (my friend has one that ways alot)...

My case didn't come with one, but it's so large it didn't really matter. Only thing that was a pain was putting in the watercooling stuff.

Alright I'll forgo the chipset block. I was just going to buy one low-profile block because the one on my 6800GT is low profile and when I upgrade everything I'm going to take the block off that card and put my NV5 back on and use the 6800GT with a 246 Opteron and Tiger K8W setup that has a...

Alright, I just started building my new system with a 3700+, DFI nF4 UT SLI-DR, 1 gig of Corsair XMS TCCD mixed with another gig of OCZ Plat. rev. 2 TCC5, 2 eVGA 7800GT's, Danger Den TDX, DD maze 4 gpu low-profile ( and I'm going to use the block on my 6800GT too), and two Hitachi T7K250's. I...

Yea UTT stuff needs 3.2-3.4V to get a good overclock out of them.

Yea your right, I'm pretty sure they don't go that high, sorry about that.

If I'm not mistaken, doesn't 250 at 2-2-2 perform similar to 290-300 at 2-7-7-8 or higher if it won't run at that?