Recent content by rheteric

Well, I don't have a 12V DC adapter so I guess it'd be best to buy a new fan that runs on 120VAC. Thanks!

Will this adapter work with this fan ? The adapter appears to be a 12VAC 1.25A output and the fan appears to be DC12V 0.35A input. I've never known a transformer to output AC current, am I reading this correctly? Thanks!

Finally some useful info..... can you tell me what BIOS rev you're running? Also what HSF and thermal paste? Thanks!

I got this Athlon XP 3500+ from newegg, and a Jetway A210GDMS-Pro mobo. My temps are read using MyGuard software supplied by Jetway. My CPU temps are in the 50 to 60 deg Celsius range. I've mounted CPUs before with no problem. I am pretty sure that this mobo is reading the temps inaccurately...

^^^ Is there anybody out there? -Another brick in the wall.

What should I make of this; bad purchase decision? I think it's a good thing from a performance standpoint, appears to be pretty stable. Could it be unlockable, or is the other core defective? My concern is that this inaccuracy could confuse some programs. For instance, I D/Led RMclock. It...

I just ran CPU-Z / cpuid on my system which I built about a month ago. CPU-Z says my core is a manchester. I bought this 3500+ Venice CPU from Newegg. There nothing else to indicate it's a Manchester. Any ideas?

Truth be told, I have no problem putting a PS upgrade on my wish list..... for future reference, is the Liberty a bolt n swap, or is there modification required. I also noticed someone using the Rosewill RP500. Looks a little cheaper, any thoughts? Also there's a dual 12v rail RP500...

No problems so far with the stock PS. Voltages are on spec, running 3500+ Venice OCed at 250 x 10. Everything appears stable. Couldn't be happier with my Qpack.

This is in line with the temps I'm seeing. 3500+, 2500Mhz, 1.5v with Zalman. I know this is an old thread, but has anyone reache d aconclusion here?

I've heard mixed opinions regarding OCing and using CnQ, I'm going to give it a shot. I found this thread which outlines things pretty clearly. Since reading this, I do think my OC settings are affecting the operation of CnQ. In particular, the hypertransport settings. My board allows for HT at...

OK, CnQ driver is installed and enabled in the BIOS. I haven't noticed any indication of it working. I do have some overclocking, my concern is that my idle temps are a little high, causing the fans to continually run at 100%. My idle is anywhere from high 40s to low 50s. I've never seen the...

I was making my speed assumptions bassed on some Sandra benchmarks. My speed was way below what they advertised for my mobo when running in single channel mode. Once it realized dual channel, the graph went up considerably. I didn't notice any marked increase in speed, all I care is that I'm...

I thought I did, but I will look back and make sure. These drivers would be on the mobo disk, correct? Or is this something AMD supplies?

Have a Jetway A210-GDMS-Pro. It supposedly supports Cool n Quiet. Where can I verify this feature? I don't see it in the BIOS. Anyone seen this before? TIA