Recent content by Radiohead1957

I use both 6600 and 9450 chips and fold. A 9450 running stock speeds will complete a unit in the same amount of time as a 6600 clocked to 3ghz. Just my two cents.

Well I've been rnning my Rev C1 9450 in an Asus P5K Premium WiFi mobo for several weeks now and have noticed one thing. It may be the settings I'm useing for memory or something but the 9450 at stock FSB and multi (2.66ghz) will crunch a FAH WU in the same amount of time as a Q6600 running at...

When I first obtained the wifi I couldn't get it to boot with the 9450 and had to swap a 6600 into the board which ran fine for a couple of weeks under load so I knew that the board was fine. Flashed the bios to the 0612 before trying the 950 again, swapped in the 9450 and it ran fine but my...

I had one hell of a time with my 9450 on the P5K Premium WIFI but evetually got things sorted out with the 0612 bios. Runs like a charm now.

Keep in mind that Dual channel memory controllers found on todays CPUs rather than the motherboard itself can be rather finicky when it comes to memory. If you can afford it you may indeed be in for a pleasant surprise if you invest in two identical sticks. They will result in a much more...

I think you're right. That being the case matrix may be in for a hit in the pocketbook.

Got this sorted out. Apparently all the RDX boards crash using speedfan MBM everest etc. I has something to do with the way the monitoring programs scan the SMBus which causes the system to crash immediately. Speedfan can be used but must be modified so that it doesn't scan the SMbus. I was...

I'll vouch for the Asrocks 939 Dual SATA2. I was skeptical but they are great boards and run both AGP and PCI-E cards equally as well. There are a couple of other boards about but the AGP ports are often emulated and the performance suffers significantly. As far as I know they are still available.

Heres a good option. The Asrock 939 Dual SATA2 or the 939 Dual SATA2 VSTA. These boards have both AGP and PCI-E graphics slots and both perform equally well. Its most likely the only board with both kinds of slots where both PCI-E and AGP both work very well. There are a couple of boards with...

A friend of mine asked me to buld him a computer and he already had the mobo CPU RAM etc so I undertook the task today. CPU 939 3200 DH-E6 2X152MB Hynix RAM 6600gt PCI-E vid card Mushkin 550watt power supply (must say I'm extremely impressed with this unit) LG DVD-RW Samsung Spinpoint...

Well robble its fairly obvious I like DFI boards just haven't had the nerve to try the expert. You appear to be haveing good luck with yours. If I had to pick my most finicky board it would be the RDX. It just takes a bit of getting used to is all. It appears to be more picky with RAM than any...

The very reason I avoided the expert personally. Heard of too many folks haveing too much trouble and these acquaintances are by no means novice builders. They all knew there stuff just couldn't put up with finicky hardware. My first DFI was the SLI all the rest I've acquired are all LP Ultra...

Usually when they stop like that its immediately after the bios has detected that the temps don't require the fans to be running and shuts them down. It sounds as though you may still be missing something in the bios but I'm not familiar with the board. Wisk I could be of more assistance but it...

I wouldn't worry about the AGP drivers unless you started having problems down the way but they should prove problematic or haven't in my past dealings with the board.

Sure it would be cool but if you aren't gonna use it why bother 2 gigs is plenty for any operateing system. XP 32 bit won't even recognize all 4 gigs, XP 64 bit will support all four gigs and I'm sure vista will but this fella ain't goin anywhere near vista till the bugs are all ironed out. When...