Recent content by EtherealConstruct

I verified that my driver is the latest off of the Asus website. I'm not sure how to check the firmware of the external drive nor how to update it? Also, if I'm not even getting the LED on when using a USB 2.0 drive in the USB 3.0 port with legacy enabled, isn't that indicative of the mobo not...

I've got an issue with both my front and back USB3.0 ports (front panel USB plugged into header). I can't use any of the ports with my USB 3.0 External Drive (WD passport) although the white active LED is on. Windows never recognizes that it is connected. I can connect to it through any of the...

At first I thought my old Salmosa's middle-click was just broken, but then I discovered that their software just deactivates it. I know that the click is registering because I can set the middle mouse click to a left click, and it works perfectly. However, I can't get it to be utilized as a...

Yup, the corrosion was black-ish. That's probably what it was, I just figured since I was in there already I might as well cover all the bases. Looking forward to some gaming after I finish bleeding all the air out!

Whew.. temps are so much better now. I think there was a lot of restriction in the block due to a build of of particles and some type of cardboard in it haha. This block is brand new, been running for ~ 1week :/ There was also some corrosion in it (surprised to see that already too), cleaned...

Ok, looks like I am going to have to take it apart this weekend. Anyway I tilt, there is no telltale rush of bubbles. I think either there is something going on with the block's internal channels or its contact because the flow of the loop in general seems ok (rush of water into reservoir, good...

Res-> Pump -> Rad -> GPU -> CPU -> Res I flipped it upside down and all over the place to try to dislodge any stray bubbles that hadn't been bled out. The water level in the reservoir did go down a little, suggesting something got knocked loose. This causes the coolant to foam up though (force...

Double-checked instructions. No specific inlet/outlet. Will have to wait to check mounting of GPU block, but will do that as well.

CPU 34-35 C idle, 50-56 C load (Prime95 blend) GPU starts like 40 C idle then rapidly rises to 99+ through Furmark Flow seems to be ok, not just a trickle.

Hi guys, I got my first watercooled loop up recently, and I thought everything was going fine, until I tried to play a game. The game has some bugs, so it might not be this, but the game was crashing my system after playing for only a very short time. I decided to download FurMark and GPU-Z...

I can feel the GPU block getting very hot under load- so something is transferring a lot of heat- it seems like it's just not getting wicked away fast enough. Will still try to re-mount the block though, thanks.

Hi guys, I got my first watercooled loop up recently, and I thought everything was going fine, until I tried to play a game. The game has some bugs, so it might not be this, but the game was crashing my system after playing for only a very short time. I decided to download FurMark and GPU-Z...

I can vouch for this member, he is my brother. Bump!

TTT