Any issues known running (2) GTX590's on a EVGA X58 Classified3 mobo? Says it can run dual or tri sli, but would 2 590 card technically be quad sli?
My first thought is that it will see the 590's as just 2 single cards and not be an issue, but I am not sure if there is more to it that I am...
I am looking to swap out my current video cards with two water cooled GTX 590's but I on'y want to use a temporary setup for the time being.
I have a Raven II case and prefer to build a complete new PC in the near future so I don't want to invest in making a complete system using the Raven...
Can't tell you without looking, but it's all set to the highest settings. I just made the assumption the 3 cards would run it at that. Haven't had the time to lower the settings yet although I understand thats something I should have tried to do first. Hope to give it a try this evening.
Anyone running, or can point me to benchmarks of BC2 running at 2560x1440 with tri-sli GTX285's and an i7 overclocked to 3.6?
I'm getting a lot of jumping in a busy game and I haven't done any changes yet to see if it's the cards lagging behind or the monitor. Monitor is a u2711 and I already...
I don't have time to read 44 pages about the U2711, so here's a new thread that can be answered and closed in a few posts I hope.
Picked up a U2711 and when playing BC2 I get a lot of jumping, but my ping rates are around 80-100 and normally wouldn't jump with my old monitor a 2005WFP.
I...
Should be possible. I'm at 3.6 with a 920 and full load after 15 min. has my hottest core right at 69-70C with HT turned on and speed step on and turbo off. Don't remember my vcore at the moment though.
Running push/pull with two gentle typhoon fans at 50cfm each (1450 rpm fans approx.)...
Following up with the contents of this thread. A 9°-10°C difference between cores on my i7-920 would be borderline?
I'm running at 4mhz with a vcore of 1.24.
High temps are:
74
72
70
66
While doing the torture test in prime95. About to run 3D mark vantage and see how it does.