AFD
2[H]4U
- Joined
- Aug 7, 2013
- Messages
- 2,154
What size screwdriver should I be using to build in the M1? I was using a size 1 philips driver to try and remove the side radiator bracket to fix a slight wobble with the rear left foot but found the screw to be quite tight and my screwdriver was skipping over it. ( The screw was not stripped but a bit of paint was worn away on the top )
Dunno? I used a screwdriver with several different sized philips bit adapters, and none of them seemed to work too well without skipping and marring up the screw heads.
I'd really like to replace them all with stainless hex screws at some point (a couple guys did that a long while back here and here).