jinx083464
n00b
- Joined
- Aug 5, 2008
- Messages
- 11
My 1000w ultra X3 PSU was reading at 4.1volts on the 5V line, the 12v and 3.3v were not too far off though. I only realized this after my computer couldn't access my hard drives any more. I thought the problem was with the hard drives at first until I swapped them into other computers and they ran fine. I don't even know if the hard drives run off the 5v line but I was wondering if this is the obvious cause or not. If so should I expect any damage to my other hardware if my PSU has been off by such a large % for extended periods of time?
I have had a lot of problems with my computer of the past month or two, and I'm thinking the problems are from the PSU and or the mobo. I'll list off a few of the problems
- screen will flash black sometimes, through process of elimination I have determined that its not caused by software/drivers, the GPU, monitor, BIOS.
- mic stops picking up sound sometimes, usually triggered after coming out of sleep mode, or just not functioning when I start the computer up. If I boot windows and it works, as long as I don't go into sleep mode then its reliable.
- Hard drives not booting.
- Computer seems to lock up whenever it needs to access hard drive or cd drive making simple processes take literally 10x longer than they normally do. This problem is intermittent. When it has the problem it has it constantly, and when the problem goes away everything runs smooth.
- starting just today when booting up my system I got a "Bad or Missing command Interpreter. Enter the full shell command line: Command.com /P /E:256" message
I have had a lot of problems with my computer of the past month or two, and I'm thinking the problems are from the PSU and or the mobo. I'll list off a few of the problems
- screen will flash black sometimes, through process of elimination I have determined that its not caused by software/drivers, the GPU, monitor, BIOS.
- mic stops picking up sound sometimes, usually triggered after coming out of sleep mode, or just not functioning when I start the computer up. If I boot windows and it works, as long as I don't go into sleep mode then its reliable.
- Hard drives not booting.
- Computer seems to lock up whenever it needs to access hard drive or cd drive making simple processes take literally 10x longer than they normally do. This problem is intermittent. When it has the problem it has it constantly, and when the problem goes away everything runs smooth.
- starting just today when booting up my system I got a "Bad or Missing command Interpreter. Enter the full shell command line: Command.com /P /E:256" message