• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Workstation (desk) question

M

mobiux

2[H]4U
Joined
Jul 24, 2000
Messages
2,626
I think this is the right place to post this since there is a workstation thread in the gallery.
So here goes...

I am looking at building a large desk in my office, it will be built into the room, basically run along three sides of the room.
I have the design pretty much planned out, the only problem i am running into in construction material.

I plan on tiling or laminating the top for a sturdier surface that just paint so...

Would it be better to build the desktop from 3/4" mdf, or 3/4" plywood?
I know mdf needs to be sealed because of the chemicals released, and it's a lot tougher to cut than plywood. So that's why I am looking at all the options.
But will 3/4" plywood hold up, not warp, under a bunch of computers and monitors?

Thanks for any help.
 
3/4" ply will hold up fine as long as you have the proper bracing underneath. I wouldn't leave 10 feet between braces and expect it to not warp.
 
A few years ago I built some shelves for my sister. She's storing lots of heavy things on them, like 10-gal buckets of wheat, water bottles, etc. I built the shelves out of 3/4" plywood, with 2x2 vertical posts about every 40 inches, with 1x2 firring strips under the front and rear edges of the shelves.

Yes, it was a bit of overkill, but those shelves are *never* going to warp. And they look pretty nice. I just wish I had some pics to post.
 
MDF is just harder to work on because of its weight and density. It's a bear on sawblades. I'd just buy a couple of those new style folding tables with the plastc top they have at Sam's club.
 
Gibroni said:
MDF is just harder to work on because of its weight and density. It's a bear on sawblades. I'd just buy a couple of those new style folding tables with the plastc top they have at Sam's club.
Click to expand...

I figured that's why it was harder to work with.
I plan on making some fairly large cuts to give the desk a flowing, "organic" feel.

I figure it will save me $10 every 4x8 sheet just on the materials, not to mention the cost of buying new saw blades all the time.

I think plywood will be the way I go.

Anyone know any decent construction software?
I have hand drawn the desk but I would like to get all measurements down before I start construction.
This is what I have in mind...

desk.jpg
 
mobiux said:
Anyone know any decent construction software?
I have hand drawn the desk but I would like to get all measurements down before I start construction.
Click to expand...
Well, optimally you would want Autocad, but that's way too expensive, especially for a one time thing. Try to find an older or eval version of it, or obtain time on a workstation at a uinversity. Alternatively I'm sure someone here can recommend something cheaper. :)
 
You are able to download a trial of sketchup. ( www.sketchup.com )

Sketchup isn't as extensive in options and ability as autocad (atleast i dont think) , but it does that trick for me.
 
You must log in or register to reply here.
Back
Top