What mem you recommend

BAC4D00R SP1D0R

Limp Gawd
Joined
Mar 24, 2007
Messages
392
Ok guys,

I have a EVGA 680i Mobo with E6300 CPU and I'm currently using OCZ DDR2-800. My cpu is overclocked to 2.8 ghz. I can't seem to get any farther than 2.8. Some of my friends thinks it's the memory since it's at 800. Would a DDR2-1066 help with my current CPU and I'm also thinking about buying E6850 for higher speed and much higher overclocking. I'm thinkin about buying those sticks http://www.newegg.com/Product/Product.aspx?Item=N82E16820227181

Any other advice about the memory selections??????
 
i didn't ask what the ram was, i asked what speed it's running at. ;)

if you don't know, then how on earth are you overclocking?
 
What you need to do is set the memory divider to operate at a lower speed. That will lower your memory speed, so that you can overclock you CPU higher.

The higher rated DDR2-8500/1066mhz memory would also help. You could leave the 800 mhz memory speed and ovrclock you FSB and CPU.
 
yea the FSB and CPU is over clocked but as for the memory it's left stock at 800 mhz speed and it seems that my cpu wont' really go any higher than 2.8 ghz
 
E6300

max mulitplier is 7 meaning you must run high FSB (400MHz) to get to 2.8. However if you have PC6400 (800MHz) ram and are running in Linked mode the memory should be right at its rated spec and if the board will do it you should have another 30-50MHz of FSB before you need to loosen your memory timings.

Read this about 5 times until you understand what is goiing on.
http://www.nvidia.com/docs/CP/45121/nforce_680i_sli_overclocking.pdf

With that cpu it is more likely the board will be your limiting factor, it is with mine. It probally needs some more Vcore to go higher, try 1.375V , watch your temps.

Oh and make sure you have set the memory voltage to the middle or upper end of what the manuf recommends. If a single value like 1.9V is given, add .1v and set your memory voltage to that.

For the time being, your memory is not the issue.
 
Back
Top