usb3/sata3 boards?

maxius

2[H]4U
Joined
Dec 17, 2001
Messages
3,377
my question revolves around sata3 and usb3 boards / laptops when will we see these advancements.
 
Checking wiki I found:

USB 3.0
Availability
Consumer products are expected to become available in 2010. Commercial controllers are expected to enter into volume production no later than the first quarter of 2010. NEC is aiming to produce its first USB 3.0 controller in June 2009, initially priced at US$15.00. Monthly production of NEC Electronics' µPD720200 host controller is expected to reach approximately 1,000,000 units in September 2009.

Windows 7 drivers are under development but no public releases have been made available as of June 2009. The Linux kernel will support USB 3.0 with version 2.6.31, which will be released around August

Didn't find an estimate date for SATA3 (SATA 6Gbit/s).
 
The controllers are in the works but it is a chicken and egg thing mobo mkg won't sink money into integrating them until they see value in doing so, and disk drive mkg won't sink money into a native solution until they see people using them.

In other words the first solutions will all be bridge devices with one to three years before you have native optimized hard drives, usb devices with built in controllers talking to onboard controllers with no bottle necks. So most likely 2012 or 2013. If some one get creative there may be an enthuist product based on a new south bridge, but right now the south bridge is getting very crowded as the north bridges are being removed from the motherboards and that means more heat and less effiencent designs based on getting everything in a chip rather than going faster.

If nvida gets their head out of of their nether region they have the 200 chips which allow more lanes in turn could dedicate serial 4x lanes to the hard drives, but we are still going to be limited by access time.

Of course if we were to get a sata3 on what would be it's own bus for all intents and purposes with 256MB of cache, that could potentially be faster than a flash drive, due to once flash drives get close to full they gth.
 
I can not give you specific information but I would say you should see something in in Q3 from ASUS. Additionally the new sata interface should be referenced by the name SATA 6G not sata 3. I apologize for the correction.
 
ah i can not wait for sata6g and usb3 its the only thing holding me from dropin my opty rig
 
Personally, I won't find these technologies (SATA 6G, USB 3) attractive until Intel embeds them in their core chipsets... and actual products that honestly benefit from it appear. I am no fan of hacked-on 1st gen. 3rd party motherboard based controllers, simply to get a feature marketing edge...
 
I can't find why they are updating the sata profile at all. When was the last time you had ANYTHING transfer to or from a harddrive at more than 750mb/s?? Most hds top out at 95mb/s , ssd's at 220mb/s - so sata 6 is like - gb lan on a 1.5mb pipeline, what's the point?
 
I recall hearing about integrating power into SATA, so you would only need 1 cable from the motherboard to the hard drive... anyone know anything about that?
 
SATA 6G is cable/connector compatible with current generation SATA. Sorry.

As SSD improves, you'll eventually see SSD hit the limits of today's SATA-II ... but if it actually hampers real world performance will likely be debatable.
 
Consumer products are expected to become available in 2010. Commercial controllers are expected to enter into volume production no later than the first quarter of 2010. NEC is aiming to produce its first USB 3.0 controller in June 2009, initially priced at US$15.00. Monthly production of NEC Electronics' µPD720200 host controller is expected to reach approximately 1,000,000 units in September 2009.

Windows 7 drivers are under development but no public releases have been made available as of June 2009. The Linux kernel will support USB 3.0 with version 2.6.31, which will be released around August.

With this being said, is the NEC USB 3.0 controller THE controller or are there other chips out there that are going to replace it? Am I just as good buying a motherboard now with enough pci slots so I can dump a usb 3.0 card in it instead of waiting for a motherboard that comes with native usb 3.0 plugs?

I'm reading about usb 3.0 being barely above current usb 2.0 speeds...does taking full advantage of usb 3.0 require hardware of software improvements?

So speeds suck a bit, however, we will see the new voltage increases and the simultaneous up/down transfers, right?
 
It'll probably be a bit before we see SATA3...

http://www.google.com/search?q=faulty+marvell+sata
It looks like that technology will be delayed, though. The only chip supporting the standard today, the Marvell 88SE9123, is having major issues. Motherboard vendors including ASUS and Gigabyte, which had planned on releasing SATA 6G technology using the chip on Intel Lynnfield platform motherboards later this summer, are having to remove the Marvell 88SE9123 and redesign their boards at the last minute due to significant speed and reliability issues.
 
looks like il have to start changing motherboards next year for sata 3 or whatever they call it.
 
I can not give you specific information but I would say you should see something in in Q3 from ASUS. Additionally the new sata interface should be referenced by the name SATA 6G not sata 3. I apologize for the correction.

Juan_Jose,

Any updates?
 
Back
Top