Thermaltake ST0005U hot swap / eject?

Joined
May 19, 2007
Messages
555
So I'm looking at getting one of these Thermaltake ST0005U units to use a whole bunch of hard drives in so I don't have to buy an expensive raid card or have a whole bunch of hard drives running all the time that I won't be using all that much.

So what I really want to know is if I get one of these units, I want to know that I'll be able to eject the drive when I want to stop using it or pop in another one. I'm going to guess there is some kinda chipset to handle translation to make it an external unit that is ejectable and all. Or is it going to basically be a pass through to my southbridge and give me issues?

If any of you guys have a theory or know for sure, post it here. Thanks!
 
Hotswap depends upon your motherboard and drivers.

These docking stations are the same as an external drive case.

I have no idea why your talking about a RAID card or a buncha drives.
 
I'll admit that the whole RAID thing and all is completely unrelated to the TT external device in the long run. It's basically make a raid array for always online storage with redundancy or have some form of storage that is only online when needed to attain longer life so redundancy isn't as needed.

I just wanted to make sure that a converter that converted a sata port off my ICH9R to one of the back pannel estata brackets would have the ability to disconnect one of the TT things attached via esata so I can remove or swap drives on the fly and not require a reboot as I'm not sure if there is some kind of chip that deals with esata in a external drive thing or if it's basically a sata passthrough and being able to eject the drive would be a function of the chipset on my mobo having hot swap or a function of the external docking system.
 
It's a function of the MB chipset.

It should work if you load the SATA drivers and enable AHCI, but there's no guarantees.

If that doesn't get it, you could try HotSwap or DriveSwap.
 
Well damn, I was hoping there was some kinda chip in there doing translation. Oh well. I have it set to RAID as my main drive is a RAID0 Array so I don't have to worry about my encoding / transcoding getting limited by disc speed.

I guess though I can do two seperate drives and reach a similar goal, one for the source and one for the destination.

Thanks for te links, if I can't get it to work with RAID I'll try those before doing a re-install.
 
Back
Top