• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Swiftech Radbox

T

TehQuick

2[H]4U
Joined
Jul 3, 2004
Messages
3,738
I saw this thing - http://www.swiftnets.com/products/MCB-120.asp and wonder if anyone has any experience with it. My case Antec SX630 is pretty small and full of stuff, and I have only 80mm fan placements, so I was thinking about getting WC setup with an external rad (dont want to mod the case). Any suggestions? thx
 
I'm curious about this thing too. I plan on using it in my build. In my opinion it doesn't look like you even need that rad box. I don't see why you can't mount the fan and heater core right to the back of the case. I know I have a grill for the rear case fan that protrudes out a bit that and might need to be sawed off.

I also can't figure out which way the fan blows and why no fan shroud is being used. I assume it pulls air from the back of the case and into the radiator. I can't imagine it would pull from the radiator and push it into the case.

I'm going to set mine up so it sucks air from the case and pushes it through the radiator.


On a side note.....
I read a review on the radbox and the person using it had to reverse the radiator so the barbs point away from the case instead of towards. There were tighter bends when the barbs were facing the case.
 
You must log in or register to reply here.
Back
Top