sladesurfer13
n00b
- Joined
- Jul 6, 2016
- Messages
- 57
I was bored today so i added a spring loaded handle to my ITX case...Tried out my new Hand Riveter
Last edited:
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
took the psu off before doing the MODI hope for your sake none of those drilling chips found their way into you psu.
No i didnt. I try to also use Rivets as much as i can compare to screws since they are stronger and cleaner. Also you see its attach to the edge(where you see the line). that edge is much thicker/strongernice. you put any thing for a backer?
if its not twisting the case thats good but it looks like your holes might have been a bit big. three look like they are trying to pull through. last time i did this i put a backer plate to add some rigidity.No i didnt. I try to also use Rivets as much as i can compare to screws since they are stronger and cleaner. Also you see its attach to the edge(where you see the line). that edge is much thicker/strongerView attachment 248823
I did drill i little bit big..lol but it is very secure no bending/twisting. Happy with itif its not twisting the case thats good but it looks like your holes might have been a bit big. three look like they are trying to pull through. last time i did this i put a backer plate to add some rigidity.
if its not twisting the case thats good but it looks like your holes might have been a bit big. three look like they are trying to pull through. last time i did this i put a backer plate to add some rigidity.
yea, but for now its good enoughThose rivets need to be redone. They aren't far enough through the holes. I know the location was probably not helpful, but those need to be done again.