Hi, recently i overclocked my computer via the fsb by 2 per boot. i was at 226 fsb and everything seemed to be ok. I then went to 228 and boom. my computer wouldnt boot. It appeared as tho my computer stopped detecting my raid drives. I then went back to 224 and it then detected the drives again but said that my windows/system was damaged and to try to repair the files via windows recovery console from the XP cd. i then tried to go all the way back to 200 and still kept getting the same message. I finally decided to use the recovery console but it was really hard to figure out. i did a chkdsk /p command and it found one error on the volume of my partion with the raid set and it fixed it but i was still getting the same thing. I finnaly said screw it and decided to reinstall windows. the wierd thing was when i went into reinstall windows on the one partition it said it was an unknown format instead of NTFS. i thought this was strange. anyway im now on the new format thing and everything is looking good. im now down to 218 fsb but im wondering what could have happend?
Is my SATA baracuda drives in raid 0 config run off my FSB? if so how can people pull 230+ fsb if my computers kicking out at 228?
any idea how to fix the files on the hard drive rather then have to completely reformat if something like this happends again?
I have a 3500+ and an asus a8v deluxe with 512x2 corsair 2-2-2-5 ddr 3200 mem and a 520 watt vantec stealth power supply. 2 seagate baracuda 7200 rpm 8m sata harddrives in raid 0 config.
Im using the via raid controller.
any ideas how to increase my overclock without running into problems like this? and any answers to the questions above?
Is my SATA baracuda drives in raid 0 config run off my FSB? if so how can people pull 230+ fsb if my computers kicking out at 228?
any idea how to fix the files on the hard drive rather then have to completely reformat if something like this happends again?
I have a 3500+ and an asus a8v deluxe with 512x2 corsair 2-2-2-5 ddr 3200 mem and a 520 watt vantec stealth power supply. 2 seagate baracuda 7200 rpm 8m sata harddrives in raid 0 config.
Im using the via raid controller.
any ideas how to increase my overclock without running into problems like this? and any answers to the questions above?