Primer? how much

S

slaya

[H]ard|Gawd
Joined
Nov 10, 2002
Messages
1,132
Hey I primed my side panel, waited a lil bit(around 15minutes) and re-primed it and then wet sanded it down with 600grit and around the edges i got down the the bare metel but it was all flat.. do I need to re-prime and re-sand?
 
You dont have to but if you want a completely even paint it would be best to prime it again and then wet sand lightly. with a sandable primer you dont have to sand much, just enough to get a smooth service. Also when you do aply the paint rember where the bumb is and to sand ever so lightly over it otherwise you will be repainting it again. How big is this Spot as you might be able to get away with not repriming it.

JEEVES
 
JEEVES/whohasmyname? said:
You dont have to but if you want a completely even paint it would be best to prime it again and then wet sand lightly. with a sandable primer you dont have to sand much, just enough to get a smooth service. Also when you do aply the paint rember where the bumb is and to sand ever so lightly over it otherwise you will be repainting it again. How big is this Spot as you might be able to get away with not repriming it.

JEEVES
Click to expand...

around the edges i got down the the bare metel
Click to expand...

there
 
the entire edge all the way around or just one spot on the edge. Come on man that is being kinda vage as to how much metal is showing.

JEEVES
 
You must log in or register to reply here.
Back
Top