ok ... computer started the sudden reboot
i was overclocking so i went back to stock ... still had the problem.
then it got worse ...
it would start ... go through the bios ok ... but just hang when it started to go to windows ... like it was going into standby mode.
needless to say
i tried:
another processor
another graphics card (2 actually 1 pci-e, 1 old pci card)
different memory
Even bought a new motherboard and tried it
took out all extra cards and disconnected extra cables (lan etc)
another brand new hard drive (not even formatted yet)
different keyboard ... no mouse
even went from DVI to VGA in case monitor cable was bad
then for some reason i tried underclocking the processor to 4.0 multiplier and it boots up now. If i raise it even to 4.5 it locks up.
BUT ... i've tried 2 different processors
either both processors are fried or it's something else
turning down the clocking on the processor would reduce the power load on the power supply, wouldn't it?
could it be the power supply?
or could turning down the clocking be changing something else?
thanks for any help ... i'm kinda fried about it
i was overclocking so i went back to stock ... still had the problem.
then it got worse ...
it would start ... go through the bios ok ... but just hang when it started to go to windows ... like it was going into standby mode.
needless to say
i tried:
another processor
another graphics card (2 actually 1 pci-e, 1 old pci card)
different memory
Even bought a new motherboard and tried it
took out all extra cards and disconnected extra cables (lan etc)
another brand new hard drive (not even formatted yet)
different keyboard ... no mouse
even went from DVI to VGA in case monitor cable was bad
then for some reason i tried underclocking the processor to 4.0 multiplier and it boots up now. If i raise it even to 4.5 it locks up.
BUT ... i've tried 2 different processors
either both processors are fried or it's something else
turning down the clocking on the processor would reduce the power load on the power supply, wouldn't it?
could it be the power supply?
or could turning down the clocking be changing something else?
thanks for any help ... i'm kinda fried about it