Post your Best AMD64 3200 Overclocks!!

Joined
Dec 1, 2004
Messages
27
Okay i gotta say I'm excited, and that i have been helped out by a few jaded geeks around here. Geeks is a good word, so no disrespek! I oced my system:

msi neo2 platnm nforce3 bios 1.4
amd64 3200 2.10 Stock Speed
XP90 H/S Tornado 119CFM
2x512 Corsair XMS 1T 2.5-3-3-8
2x60gb maxtor sata raid 0
ati 9800xt
psu-> I'm too embarrassed to say!! Its a temp!! I swear!!

The system is oced from 2.10 ->2.55. I did reach 2.6 and it ran fine on the desktop but when i loaded counter strike:source it crashed in about 5 minutes. I didnt go past 2.6. I just did this today and plan on running prime95 all night tonight.

To achieve this result, and by no means without good help, i set the HT to 4x, set the dram to 166mhz or 4:5 ratio, and then rasied the FSB in increments of 5mhz until i hit 2.6. Does this sound all correct? Am I really running at 2.55ghz? or am i just reading this whole thing wrong? Correct me if you can and offer some advice for me and others who have this similar setup! Also, post your OC experience with tthe 3200, thanks!
 
i donno, i know that the L2 cache for the 3200 512, where the 3700 has 1mb L2cache. As far as speed goes, and i might be wrong here. but this cpu is running faster than the stock speed of the amd64 4000. I dont think this is uncommon, but im sure that im missing something here as far as whats behind getting my cpu to overclock in comparison to a 3700 stock cpu. So i really dont think i can answer that question becuase im not as overclocking savvy as my ghz might imply! muhahaha
 
looks good more like 3900+ oh try running 2.5-3-3-10 ^.~

also try 260 with a 3x HTT bet it just didnt like the HTT over 1Ghz its a bit picky about that
 
nope unstable at those settings. It posted and booted to windows, but crashed when i played hl2 in 3 minutes. You think that this can be a video issue that i have to resolve? My above specs are a bit fudged. I am currently running a geforce3 on this machine. The 9800xt is en route to my address. Any ideas guys?
 
hey guys what do u mean when u say htt? i probably know it i just havent heard it called htt before
 
FSB, it's the AMD "version" of the FSB, since the memory controller is on the cpu (I think).
 
Correct.

as far as my OC on my 3200+ winnie... well the thing hates me and it OC like a piece of crap.

i cant get past 210 stable..... its fucking stupid
 
Elios said:
hmm more Vcore what you at right now?

vcore is set at 1.55

I'm running right now at 2.58ghz. I ran prime95 and the machine ran for 1 miunute and stopped. But i played hl2 for 30 minutes without a crash. Now at this point if it can run on the desktop and run my games without crashing that all i care about. I might face blue screens every once in a while, but thats okay for me becuase the speed is the tradeoff.
 
my 3400+ newcastle runs at 2.6 with default vcore, i have not gone any higher because quite franky that is PLENTY fast
 
Well I got a new mb and hsf, so I will prob be trying to oc today or tomorrow. So I will post my 3200 A64 results..
 
my shuttle does pretty good for a weak psu and just adequate cooling
ive got the sn95g5 with

winchester 3200+
9800xt
250gig HDD
dvd-rw
card reader/floppy
pci 802.11 adapter
all on completely stock cooling (innovatek watercooling coming soon, when i'm less poor)
so thats the 92mm ICE heatpipe

i get 10x220 on 1.4 vcore (stock, although i have to set it at 1.55 to get that 1.4)
if i up it to 1.5 vcore, i get between 230 and 240 x10
this is on 5x HTT, with bufallo crapstix pc3500 running at 2.5-3-3-7
 
prime95 doesnt work with the 90nm chips, something with the onboard memory controller causes prime to crash even though the OC may be stable, i read that you should use, super pi and CPU burn in instead.
 
my a64 3200+ newcastle is running smooth at 3400+ all stock (2.4) but once i get teh new zalmans that came out im gonna push it to 2.6 or atleast try
 
CPU-Z

Ram Divider is at 166 if I try 200 I can not get any higher then a 210FSB. Haven't tried any higher then that yet, getting tired of the whole raising, run tests ,shutdown,raise some more,test shutdown thing.
 
Main Target said:
prime95 doesnt work with the 90nm chips, something with the onboard memory controller causes prime to crash even though the OC may be stable, i read that you should use, super pi and CPU burn in instead.

Prime95 works fine with my CPU. Do you run the In place Large FFT's to stress CPU or the Blend with lots of memory?
 
Um, I got my 3200+ Winnie on my Abit AV8 K8T800 Pro from 2.0GHz to 2.7GHz on full voltage (1.75V) and it was for the most part stable, but on warm days the temps climb too high (almost 68 load, around 51 idle). I had it 270MHz x 10, with a RAM divider of 6:5 (DDR333, instead of DDR400). I have benchmarks from it, but I don't keep it at 2.7, usually at around 2.55Ghz or 2.6, @ 1.625 Vcore. I cool this baby with a Thermalright XP-90 and a high CFM 92mm fan, and 3 intake fans and 3 exhaust.

Main Target said:
prime95 doesnt work with the 90nm chips, something with the onboard memory controller causes prime to crash even though the OC may be stable, i read that you should use, super pi and CPU burn in instead.

Yeah, I noticed that, my 3200+ won't run stable with Prime95 at even a 10MHz OC, it says that the "rounding" was like .something, and it expected .4. So I use the CPU burn in thing. I would use the memory thing, what do you use kirbyri?
 
3200 winch CBBID 0506

2.6ghz @ 265x10

BH5 corsair XMS PC3500 1.1 @ 265mhz 2-2-2-9 1:1

The cpu will do 2.7ghz if I drop to 9 mult and run a mem divider... but I want 1:1 so... :rolleyes: Damn CBBID's clock for crap I think.
 
Hey

3200 Winchester week 41 of 04
2.6ghz @ 260x10 with 1.4volts
Stock cooler
Corsair TwinX 3200C2 2x512mb 217mhz 3-3-3-8 1T

Shadow27 :)
 
Hello,

After spend a lot of time playing with cpu and memory timings i've have my system stable with following settings
A64 (Winnie) 3200+ @ 2.40 (240x10)
Asus A8v de luxe
HTT: 800 divider 5/6
Ram 2x 512 corsair twin1024xl pro, setting at 2-2-2-5 and 2,7 volt
Have Prime 95 run at 5 hours stable
Cpu voltage 1,55 volt in bios 1011.005 and on CPU Coolermaster Ultra Vortex
Cpu temperature 35C normal, heavy stress 45C-47C
PCI/AGP locked at 66/33
2x Hitachi SATA 250 in 0 striping on via controller, Result HDTACH 3.01.0 = 181,9 mb per sec
Audigy 2 Platinum
Plextor PX-716A
Hercules Radeon AIW 9800 SE 129mb
CoolerMaster ATC /Topower 520 watt/2 fans
Results Sandra bandwith INT 4950 FLOAT 4925
Results everest home edition memory read 5819, memory write 1759, memory delay 49,1 ns

I hope someone can use them.
Greetings out of the netherlands :)
 
Back
Top