Overclocking 9NDA3+

H

Herulach

Gawd
Joined
Dec 24, 2004
Messages
997
Im having some issues with overclocking on this board, with my Winchester 3200.

Its probably just me being dense. I remember reading somewhere that the HTT should stay below 1GHz, so i knocked HTT multi down to 4x, Given that ive only got cheap ass DDR 400 (think dabsvalue 8-4-4 at 2T eugh) till i get my ballistix some time around payday I set up a 5:4 divider (max mem overclock = 166). Then ive tried gradually knocking the speed up, but i cant for the life of me get it to take above ~2.2Ghz, setting teh fsb to 210, and 220 both works, anything over that it just resets back to 200.

Am i missing something? Or am i being too ambitious with speed so its resetting itself. I know its not the memory, cos thats running at DDR400 even at 250 fsb.
 
Did you bump up the Vcore voltage any? I would also lower that HTT multi to x3. My 3200+ winchester wouldn't do more than 2.2Ghz at stock voltage but runs fine at 2.4 with 1.5V.
 
Vcore is up +.05 its not an issue with the thing not posting, it literally just wont save teh changes, unless its just resetting itself because it wont post, which although a neat feature youd think it would have a message or something
 
Herulach said:
Vcore is up +.05 its not an issue with the thing not posting, it literally just wont save teh changes, unless its just resetting itself because it wont post, which although a neat feature youd think it would have a message or something
Click to expand...
it doesnt exactly reset it, it leaves the setting alone but stays in that screen
 
You must log in or register to reply here.
Back
Top