Novice question - screws

GDstew4

[H]ard|Gawd
Joined
May 16, 2006
Messages
1,380
Putting together a PC for my mother-in-law from some leftovers of my last build.

Just curious if leaving out screws from a motherboard installation might cause a short circuit. I have 6 out of 9 screws installed since I can't seem to find the other 3 at the moment, and the system won't boot. It'll turn on and get the fans going, but that's where it sits. No BIOS or POST beep.

Other possible factor:
350W PSU has a 4-pin 12V connector but only a 20-pin main connector. The motherboard has a 4-pin and a 20+4-pin connections (I was able to get the system working and OS installed with a 400W PSU that had the same 20-pin main connector, so it doesn't seem like that should be the problem. It also worked with the 6-out-of-9 screws installed)

The system was working fine at my house. It was working fine when I initially set it up at her place while she was at work. She came home and said she'd like the tower on the floor instead of up on the desk. I moved it to the floor and now nothing works...:mad:
 
No, not installing all screws won't cause that. The 20-pin connector in a 24-pin slot is fine as long as the 4-pin connector is plugged in as well. It almost sounds like the CPU's heatsink/fan was jarred too much though or perhaps it was tightened down too much. Perhaps try reseating it and trying it out again? Also, check that the RAM wasn't bumped out of whack as well. You know, the usual suspects. ;)
 
Back
Top