not booting from onboard controler

Wang191

[H]ard|Gawd
2FA
Joined
Nov 30, 2000
Messages
2,026
I have an old soyo 6ba+iv mobo and right now the c drive is booting from the IDE 1 channel. This is just the dma33 connection. I want it to boot from the onboard dma66 connection. This is a highpoint dma/66 controller.
I went into the setup and it is set as the boot drive but it wont work.

I then went into the bios and switched it from booting from c drive to boot from scsi thinking maybe that was it but still nothing.

Am i missing something?
 
When you install Windows, you need to specify the secondary controller drivers or else it won't locate the drive properly. This depends on what version of Windows you are running. WinXP/2000 needs a driver floppy and you have to press F6 at a certain point during installation.
 
i'm running win 2003 server.
Since i had it running on the other ide controller windows is already installed and i installed the drivers for the controller card after the fact.

Am I out of luck with this?
 
What happens at boot? Does it try to boot into Windows and just not make it?
 
it gets to the step right before it boots, typically where if you had a non bootable floppy disk in drive A it would tell you it's a non system disk. It just sits there. I can reboot with ctr+alt+del at that point still.

There's no further messages or anything.
 
Back
Top