New PC problem

Hyperian

Limp Gawd
Joined
Mar 20, 2006
Messages
181
sorry if there's already a lot of pc problem threads...

Here are the parts that i bought
Gigabyte GA-965P-DS3 rev.2
VGA BFG 7600GT 256MB
APEVIA ATX-CW500WP4 RT
Intel Core 2 Duo E6300 1.86gb
OCZ DDR2 800 1gbx2 OCZ2G8002GK

Here's the problem:
I installed the mobo, gfx card, ram, on a test bed(old case) and hooked them up with the APEVIA PSU and do a test run to see if everything worked.
I booted up and everything, i was able to go to bios and see the settings no problem.

I took it apart, and also took my old computer apart, and installed the new parts in. (so basically i just changed from one case to another)
It stopped working, I press the power button and most of the time the fan would just spin up and then spin back down, turned off(the thing would just turn on and off).
If it doesnt turn off by itself It would turn on but does not do anything, the monitor wont reg any activity at all.

What i've done:
1. I took out the parts from the case and put it back in the test bed(old case). Same deal now.
2. I took out the gfx card and put in an old pci video card and Same deal.
3. i took off the HSF on the proc and checked the proc, nothing wrong and put it back in and turned the thing back on, Same deal.

side note: while installing the HSF (HSF came with the intel proc) i notice that you couldnt physically push all 4 pins in so it will click, because it would warp the mobo so i push the pins in diagonal order as firmly as i can locked the HSF in place.

any tips, help would be great.
 
you're absolutely sure that hsf is on properly? thats what would happen if it weren't (pc would power up and then back down, mobo temp autoshutoff kicking in)

also, I don't suppose you have a spare powersupply to play with?

check for any shorts/loose connections as well.
 
I pretty much had the same problem, I couldn't figure it out so I game up and am parting it out (older dell desktop) feel the heatsink after you turn it and see if it is warm, if not then the CPU isn't doing anything. Then it is narrawed down to the mobo or cpu.
 
This is often caused by a short.

Remove ANY WIRING you don't need, INCLUDING ALL DRIVES and CD-roms.

Remove all fans that ARNT connected to the motherboard.

Reseat all your components (CPU, RAM, GPU, PCI cards).

Make sure there are no "extra" mobo standoffs shorting a component or 2 on the board.

Start up WITHOUT the case switch, use a screwdriver to jump the pins.

Start up outside the case.
 
thank you all for all you help i managed to get it work. it seems like i didnt install the heatsink in a particular way, or the way i did it the first time i installed the thing (without reading the instructions)

anyways i got it to work and now am trying to figure out how to move my raid from my old computer(which used a sata card) to raid in this new computer. couldnt do it since it doesnt see the 2 drives as raid and i assume if i try to create raid the data will be deleted...
 
Back
Top