Need a part - 2-port sata riser

Status
Not open for further replies.
Joined
Mar 20, 2005
Messages
665
Could use some help locating a supplier who will sell a one-off of something that I can solder on to this board down in the lower right corner where it is silkscreened "SATA56"



Looks like it has 16 pins with maybe a couple of screws for grounding?

I'm hoping someone out there can point me in the right direction.

found what I want but it says its 'obsolete'

Any thoughts?

http://www.tycoelectronics.com/catalog/bin/TE.Connect?C=1&M=BYPN&TCPN=1470078-1&RQPN=1470078-1
 
Last edited:
Did you break them off? or was there just nothing there? (sorry, I don't know much about that board).

Either way, I'm not sure that's possible unless you're a significantly above average solderer ;).
 
It just isn't there. This is an OEM version of the RAMPAGE GENE board available at Newegg and it appears in order to not compete with themselves too much, or mostly because people who buy boxed computers never open them even once, they left a lot of the little 'extras' off. Since those 2 ports are part of the existing onborard Intel chipset it stands to reason that just a bit of solder will do the trick. If you take a look at the connection it is actually a pretty simple solder. Also of note is that this is just the SATA termination and does not contain any microarcitecture that could be damaged by the extreme heat of a soldering iron and an inexperienced solderer. Yes the pins are small but being that it is a pin-array not some sort of BGA type connection it shouldn't be too difficult (I've done very similar soldering in the past, albeit on a slightly larger scale (more like the missing IDE port you see in the same photo). Besides if I have troubles getting it on there I've got a cousin who does these things for a living so getting the thing soldered on is going to be a non-issue. I just need to find the part.
 
Can you get them off of an old board? Heat up the solder and pull them off? Would it be easier to do two individual ones as opposed to a single dual riser?

Thanks for the explanation also. I think I remember seeing those OEM boards for sale from Geeks.com or something like that (not sure if that's where you got it or not, but either way, I understood what you were getting at).
 
I actually bought a refurb system (heck of a deal, all in all) there just yesterday so yeah, that's where this is coming from. I was thinking 2 standard vertical ones would be fine but I'm not certain there is room for them there. (see photo, there is a standard SATA port at the extreme bottom right of the board, it is on another Chipset than the intel ports) I do have a current board that I could sacrifice 2 of those off of to try it but I don't have anything that I could cannibalize that has the 2-port perpendicular riser that I think i'll actually need.
 
I'm not sure how the orientation of the slots is in right angle ones already there. If they are flipped like the one you had in the OP or if they are both the same direction. I agree that you probably aren't going to have room for two singles...unless you cut off the edges (which probably wouldn't make a difference).

You might be able to get it directly from Asus if you talk to the right person.
 
Status
Not open for further replies.
Back
Top