My E6600 Temp and First Shot at WC'ing

D

DFW5168

Guest
First shot at watercooling and I am a little worried about temps.

Case is a CM Stacker. Radiator is at the front taking up 5 1/4 bays like in the instruction from Dangerden on youtube.

Watercooling consists of:

D-Tek Fuzion
Laing D-5
Swiftech MCR220 Dual 120mm Radiator
2 x Yate Loon 47CFM Fans
Swiftech Microres

Temps are 40-42 idle
around 60 under 100% load

E6600 with 1.55v @ 3.6 ghz
I have tried running under 1.55 but I get errors in Vista for some wierd reason. With it up I dont get errors booting in. Everything runs good, but just worried about temps.
 
EVGA 680i board.

On Vista also.

80c is max your temps are fine, a bit higher then I would anticipate on water, but not out of reason, considering I have a high end air solution and I'm under volting mine... 1.35v stable at 3.535 ghz... try reducing your OC a bit and backing off the volts accordingly.. just a suggestion but if you wanna overvolt it go for it!

Also where are you getting your volt readings from? I set mine to 1.4v in bios but it is only 1.35v according to Ntune and everest. Just curious :)
 
Thats good to hear. I am getting my reading of voltage from the bios, but Ntune says 1.54
It's wierd as hell, but if I lower voltage, Vista doesn't start a couple of services, like Defender. If I go lower, it actually says the copy isn't legit, which it is, system builders Ultimate. I dunno. It is nice to hear the temps are ok.

Temps in the house are around 75 degrees.

I just hear all these people getting 30c and I am wondering if I am doing something wrong? I have already taken it apart, cleaned it up nice, also cleaned up the N a S bridge from the 10 lbs of gunk from the factory. Nice thin layer of AS5 for the processor. I dunno.
 
HOLY SMOKES, 1.55VCORE:eek: . Have you tried lowing the Vcore? hitting 3.6GHz is not worth 1.55Vcore if you ask me. I would say those are DAMN good temps for using that high of a VCORE! try lowing that Vcore, and your temps will settle down nicely. Are you stable @ 3.5x using 1.4x volts? If so, the difference from 3.5 - 3.6 isnt even noticeable..
 
E6600 with 1.55v @ 3.6 ghz

Temps seem about right for that high voltage and not near max. If you think you got a good mount on the waterblock then not much more to say. Except ... as long as you are aware you have exceeded Intels maximum voltage for that chip and there are other things than heat that can cause them to fail.
 
Vdroop? What Power Supply are you using?

I'm using the silverstone 1kw OP... Its purely a mobo issues with vdroop... I mean I had another psu in there and it was the exact same voltage drop... difference was with the old psu 1.4v would not be long term stable... where with the silverstone it is 100% stable never had a crash ever.
 
Back
Top