Mobo RMAd... still no boot.

drdeutsch

2[H]4U
Joined
Sep 17, 2004
Messages
3,775
Long story short, My desktop stopped working. I managed to narrow it down to the mobo. Basically, I exchanged all the hardware one by one until I managed to boot up my cpu and RAM with a different mobo in the same case. That more or less lead me to believe that my mobo was dead.

So I sent it to Asus RMA (It's an A8N-SLI Premium) and it came back today. Same part. No errors, apparently.

Hopeful, I assemble the whole thing again and push the power switch.... .nothing.

Still doesn't boot. No fans spin, no beeps, nothing. Dead. Nada.

I'm fed up.... do I have to buy a new mobo? Is there something I'm missing? I'm going crazy here... I've double checked and triple checked everything... then I RMAd the mobo, now I put it back together and double-checked and triple checked everything adn nothing....
My CPU (X2) and RAM booted on a different mobo.

The only thing I could think of would be my video card, a 7800gt. I wasn't able to test that on the other mobo because of PCI/AGP. Would a bad video card stop the whole system from booting? I mean, no fans or anything?

Either way, it looks like I'm going to be spending some money to fix this damn thing.
Thanks for any help. I appreciate it.
drdeutsch
 
try booting outside the case with minimum hardware.. also - make sure that the power button isn't defective - try shorting pwr pins with a screw driver...
 
Okay,

I'm still getting nothing. I've got the mobo, CPU w/ HSF, RAM, and video card plugged in. The Standby Power light comes on the mobo, but when I short the pins, again nothing happens. No fans spin, nothing.

Am I shorting the pins correctly? Just use the tip of the screwdriver to connect the two "pwr switch" pins?

I'm at a loss... .I've got power from the PSU, but nothing is happening. I know the CPU and RAM works, which only leaves the video card.

1. No, I don't have another PCI-E video card to swap out.
2. Could a bad video card keep a whole system from booting?
3. If so, I guess my next step would be to RMA the video card, eh? Thank god for eVGA's lifetime warranty!

thanks,
drdeutsch
 
Hmmmm,

I tried shorting the PSU as per this page. The PSU fan didn't spin up and I still get nothing.

The standby power light on the mobo still comes on, however. So.... does this mean the PSU or...?

I'm still at a loss. I've tested the CPU, RAM, and PSU with another Mobo and it booted. I got a POST, I got fans spinning, etc. I'm thoroughly confused as to what's going on, so I'd appreciate any feedback or any other ideas to get this computer working.

thanks,
drdeutsch
 
I would try taking everything out of the case and just hooking up the basics. If that works then the motherboard was probably grounded to the case.
 
Whenever I suspect a bad motherboard I remove everything that isn't needed and also remove the ram. Without the ram the motherboard should beep to indicate there is no ram in the system. No beeps in your case would mean trashed motherboard since you know the CPU and PSU are good.

As much as I love Asus, their RMA boards seem to have a high rate of DOA. I have gotten bad RMA boards from them before. (Abit too)
 
I've tried booting up outside the case with no results. I've got the CPU w/ HSF, RAM, and graphics card. All I get is the standby power light on mobo. No fans, not even PSU fan.

I've tried the same thing with no graphics card, and I get the same results.
I've tried the same with 1 stick of ram and get same results.
I just tried with only cpu w/ HSF and get same results.

What is the bare minimum I need? CPU? That's all I've got now. I still get the standby power light on the mobo, but nothing else. No fans, no beeps, no post, nothing at all.

I've done all of this in the case and outside the case. I'm at a loss for troubleshooting this.
Thanks for the feedback so far. I need some more ideas. So far I've eliminated the CPU, RAM and the PSU. The Mobo has been RMAd, so I'm thinking of RMA'ing the graphics card, since eVGA has a lifetime warranty.

But, any other ideas before I get to that? I get the same results with and without the graphics card. I get the same results with or without RAM.... is this leading to the PSU?

If I disconnect the PSU from the mobo and short the green and black wires, the PSU fan spins up. If I connect the PSU to the mobo and turn on power, the PSU fan doesn't spin. Is the PSU not putting out enough power or could the mobo/cpu be drawing too much power?

drdeutsch
 
A couple of thoughts that may sound strange, but may work for you.

  1. First, disconnect the power supply and clear cmos. Try to boot.
  2. press and release the reset button, then hold the power button for a few (6 or so) seconds. Release the power button, then press again like you normally would. Anything?
  3. Disconnect your ps. Find your leads for your power switch on your main header for the board and reverse the leads. Plug in the power supply and press the power button. Any change?
  4. If possible, try a different power supply just to make sure there isn't a compatability issue, and go through the previous steps again.

After that, if you have all tested components and it won't boot, the board is probably toast....(a moment of silence please....)
 
Found the problem. It was the PSU. I managed to dig up an Antec TruePower 350, plugged it in and all the fans spin up, everything works.

So, I'm pretty disappointed that my Antec Neo480 took a crap on me. Anybody have any recommendations for a new PSU?

Thanks for all of your help. I really appreciate it.

drdeutsch
 
Back
Top