Lapped my conroe and got higher temps...

Kaos_Drem

Gawd
Joined
Oct 16, 2004
Messages
970
So a while ago i set out to lap my e6600, i got it down with 400 then 600 to where there was no significant difference in the surface as a mirror shine doesn't really do much but say bling bling. Anyway i installed the chip and turned on my computer and it did nothing...i thought i had fried my cpu so i checked over the bottom and found a trace amount of arctic 5 touching 2 nubs? together. I cleaned it off and turned on the comp and it worked just fine from here on out.

Now the problem, i have a tuniq 120 and my temps are actually higher than they were before lapping, i have reseated the heatsink countless times tried 3 different pastes and nothing seems to net me lower temps, granted my temps aren't "bad" but they aren't as good as they could be. I read of people with idles around 30 and loads of 38 whereas i idle around 40 and load at 50-52. My proc is mildly overclocked at 3.2ghz fsb at 355 ram at 710, and the vcore is at 1.304 with 1.288 at vdrop load. The crazy thing for me is that i actually run the coolest with arctic silver 3 instead of 5.

So the question, how do i get my temps down further without making my room a freaking freezer as that will be out of the question in a few months considering the summer is coming. And did i possibly fry something on my proc by firing it up with that trace amount of paste bridging the gap?
 
i lapped it on a plate of glass i got from home depot where i also got the sand paper. Which was the wet/dry variety.
 
If your Tuniq base is not flat like this one it could be a problem. Did you lap the Tuniq too?

heatsink5.jpg
 
yeah i lapped my tuniq as well, and it was a bitch...those things are just too massive to freaking lap well without a power sander and then you run the risk of screwing up pretty badly.
 
Power sander, lol, I can see that. I did mine with 320 for a quick cut to start. Mirror on the kitchen counter worked for me. Just remember now that the IHS and cooler base is flat, much less thermal paste is needed to bridge the gaps between the two parts. Try a very small amount of paste and twist the cooler back and forth a bit while under the pressure of the springs so it can get squished out and thin better. Good luck.

Dont compare what others post, especially if you have no idea what load they are talking about (Orthos or a game?), or if they are reading TAT temps or some motherboard mounted thermister. I like to call a load test Orthos load with TAT reading the temp. Low 60's and below is good in my book depending on how high your oc/vcore is in comparison. On my 6600/Tuniq at 3.6/1.3875 vcore (bios) TAT with Orthos load was 60-64 with the fan at 1800 rpm depending on which Orthos test was running at the moment.
 
that was one of the reasons that i used arctic 3 because i could get it much thinner and thus lower temps, i will try one last mounting of it with even less paste and see if it is that, although i don't think i will get much lower.

thanks for the replies
 
Back
Top