IP35-E

According to THIS It will work with an E8400 C0 stepping with BIOS 15, it may or may not work with an E8400 EO stepping...
 
I'd just make sure you have bios 15 on it and it should work. Seems like they were just testing to make sure and never got around to putting up results online before they went out of business, so it's kind of unofficially supported.
 
I'd just make sure you have bios 15 on it and it should work. Seems like they were just testing to make sure and never got around to putting up results online before they went out of business, so it's kind of unofficially supported.

ABIT went out of business?
 
It will work fine. A friend had this board with the e8400 and it would always do a cold boot up each time. But it work.
 
It'll work fine, but one thing to look out for during the setup of your BIOS is the temp monitoring shutdown value. I had to disable the shutdown temp on my IP35-e....even after flashing to BIOS version18, because my E8500 reported temp at 98 degrees. That value is above the default shutdown set-point of the motherboard, so on startup the computer would immediately bluescreen and hang (in an attempt to protect itself). The system ran fine after I disabled that value. I RMAed the original processor, thinking it had a stuck thermal sensor, but the new replacement did the same thing, so it's not a processor issue. It appears only some IP35-e have this issue...no all. The true temp for the original processor as well as the replacement are around 32 degrees idle according to Core_temp software. The processor works fine and is extremely stable...once the value is disabled. Just a heads up. Good luck.
 
Go to the raptor pit and ask, that's where all the folks from the abit forums went. I do recall that the EO stepping had problems.
 
Back
Top