Installed ram, no post, no beep

A

Axsuul

Limp Gawd
Joined
Aug 15, 2003
Messages
235
Ahhh

Well, I went about to install a new stick of ram into my system (1 GB) but I forgot to unplug my power supply, grrr I'm heavily regretting this. I did ground myself (I have insulating gloves too) but I doubt that helped in this case. After installing my stick of ram, I realized that my power supply was still plugged into the wall, and now my computer does not post (no beeps). I tried booting system from barebone (vid card, 1 stick of ram, no hdd, no SATA drives) but still no luck. Argh, any suggestions?

Thanks for your time! Any response is appreciated, even depressing ones.
 
Nope, still no posts. However, with no ram stick, it turns on for like a second, turns off, then turns on again. Only happens when the power supply has been cycled.
 
follow the procedures in the basic troubleshooting guide sticky thread... report error beep results.

btw, u still at uci? ;)
 
Erm alright I will try the barebones outside the case.

enginurd:

Yo, whats up man! Long time no chat. I just graduated from UCI =p Gonna be at UCLA next Fall. What you been up to?
 
You must log in or register to reply here.
Back
Top