I was working on drilling holes today in my cheap POS case, when I kept screwing up. That right there should have told me to drop it and do something else, but I was a dumbtard and kept going. Finally, after screwing up enough, I went nuts and took a hammer to the lower right corner on the back of the case. The entire chassis is gone beyond repair.
Should I try to repair this, or should I just take the remaining parts out of the case, give it a few good stomps to get this shout out of my blood, and try to make my own case? Or should I try to repair it? One corner is gone, completely... The back of the case (behind the mainboard tray) is bent, the top is no longer level with the ground... This case has been a MAJOR pain in the ass so far.
I'll see about getting a camera a little later and taking pics of what is going to go into this case, and see if anyone has any suggestions...
Should I try to repair this, or should I just take the remaining parts out of the case, give it a few good stomps to get this shout out of my blood, and try to make my own case? Or should I try to repair it? One corner is gone, completely... The back of the case (behind the mainboard tray) is bent, the top is no longer level with the ground... This case has been a MAJOR pain in the ass so far.
I'll see about getting a camera a little later and taking pics of what is going to go into this case, and see if anyone has any suggestions...