help with old PC

"It will just underclock" sounds like a load of bull -- i.e. they did not know what you were talking about and made something up to sound as if they did.
 
Actually it isn't bull. RAM can downclock itself if the mobo can't support it's speed. Thats why my PC3200 RAM will work with a mobo that only support PC2700.
 
I may have misstated their words. I think they were saying that instead of running at pc2700, it would run slower. Or maybe that's the same thing. I dunno.
 
I may have misstated their words. I think they were saying that instead of running at pc2700, it would run slower. Or maybe that's the same thing. I dunno.

Well, most of us in the know can tell ya that your memory runs as fast as the slowest module installed. So if you have PC3200 and PC2700 installed, all your memory will run at PC2700. If your computer only supports a certain number of banks of RAM, than it is possible that your computer will not detect the entire memory size.
 
Hmm. In this case, it was detecting the full 1.5 Gb, even though there was a stick of 512 mb PC2700 ram in each of the 3 available slots. That bank vs slot thing is a bit confusing.

Is there ram that is single bank vs dual bank? Or is all DDR ram dual bank?
 
A couple of upgrade scenarios... both based on the AGP requirement.

Opinions?

AMD: $187 or $200 (depending on ram)


Intel: $247 or $260 (depending on ram)
 
Two very basic things that you could have checked from the beginning:
1. What is your CPU temp showing in the BIOS and in Windows?
2. Look for bulged/leaking capacitors on the motherboard.


If you want to go the new mobo/CPU route, I would wager that Fry's will be having like a $75 combo for the e2140 and a mobo once the e2140 is released.
 
One thing that just dawned on me: the AMD board is micro-atx and the Intel board is ATX. I've never used a micro-atx before... and my box is still at the shop. Will a micro-atx fit where my standoffs are located (for atx size)? I don't know if there are provisions for micro-atx or not on that old case (Antec SK282 mid-tower)
 
Two very basic things that you could have checked from the beginning:
1. What is your CPU temp showing in the BIOS and in Windows?
2. Look for bulged/leaking capacitors on the motherboard.


If you want to go the new mobo/CPU route, I would wager that Fry's will be having like a $75 combo for the e2140 and a mobo once the e2140 is released.

I did check them: temps were in the low to mid 30's... and I always ran MBM5 and kept a close eye on temps. I also checked the caps and visually, they looked good.. as noted earlier in the thread.

But will the 2140 combo support my AGP requirement? No Fry's in my area either.
 
Sorry, didn't notice the other things.

Normally, the Frys deals come with some sort of ECS mobo. One of their e4300 combos came with a boad that supported DDR and DDR2 and had AGP. Just keep your eyes open in the [H]ot Deals section of the forums.

/edit: and you can shop at Frys on line with reasonable shipping rates.
 
Back
Top