WalkedAirplane
Limp Gawd
- Joined
- Apr 19, 2005
- Messages
- 378
Right now at 3ghz
System information:
Gigabyte 965-DS3 r3.3
4x 1gb A-DATA PC-800 DDR2
E4300
Arctic Cooling Freezer 7 Pro
Corsair HX520 PSU
Lan-Li PC-60 case (4x 80mm fans)
Current clocks:
333x 9
CPU voltage is at 1.36v
Ram is at 830mhz
+0.1v
Right now runs orthos very stable.
28C idle
53C load
My temps have a LOT of room to move I would say, but if I bump up to anything above 333mhz FSB, I either wont boot, or I will fail Orthos immediately.
I have tried bumping voltages all around, nothing. I have gone as high as 1.475v on the CPU without any success at 355x9 or higher.
Any thoughts that I may be missing?
My two top guesses are:
1) RAM (however I have tried running it at sub PC-800 speeds when clocking past 333x9)
2) I just have a chip that doesnt want to go higher
System information:
Gigabyte 965-DS3 r3.3
4x 1gb A-DATA PC-800 DDR2
E4300
Arctic Cooling Freezer 7 Pro
Corsair HX520 PSU
Lan-Li PC-60 case (4x 80mm fans)
Current clocks:
333x 9
CPU voltage is at 1.36v
Ram is at 830mhz
+0.1v
Right now runs orthos very stable.
28C idle
53C load
My temps have a LOT of room to move I would say, but if I bump up to anything above 333mhz FSB, I either wont boot, or I will fail Orthos immediately.
I have tried bumping voltages all around, nothing. I have gone as high as 1.475v on the CPU without any success at 355x9 or higher.
Any thoughts that I may be missing?
My two top guesses are:
1) RAM (however I have tried running it at sub PC-800 speeds when clocking past 333x9)
2) I just have a chip that doesnt want to go higher