Good socket 478 board?

Susquehannock

Supreme [H]ardness
Joined
Jul 26, 2005
Messages
5,035
What is a good socket 478 motherboard in ATX? Overclocking or otherwise?

Long story short ... I acquired an old HP pavilion box that is so nasty that I don't even want to fire it up. (dead mouse slime etc) Grabbed just the 2.5ghz Celeron CPU, 80gb HDD, and 1gb RAM. Then trashed the rest.
Want to eventually run some comparisons with my socket A set ups.
 
ASUS P4P800-E Deluxe or the SE.

Also ABIT IC7 just because it's ABIT =)
 
ASUS P4P800-E Deluxe or the SE.

Also ABIT IC7 just because it's ABIT =)
Thanks. Putting those at top of my list. Reading back to older posts here it seems the Intel 865PE based boards are well regarded.

The IC7 would be cool since I will be using an Abit KR7A for the AMD system.
 
1. Grab Celeron
2. Throw Celeron in trash
3. Get a real Pentium IV - not Prescott as the IPC is lower than Northwood, even with the extra L2 cache.

Athlon XP walks all over Pentium IV as far as IPC goes.
 
1. Grab Celeron
2. Throw Celeron in trash
3. Get a real Pentium IV - not Prescott as the IPC is lower than Northwood, even with the extra L2 cache.

Athlon XP walks all over Pentium IV as far as IPC goes.

What just about to say a more fair comparison to the Netburst Celeron trash would be something from the socket 7 days.


$7 P4 2.40/533/512 Non-HT
$8 P4 2.40/800/512 HT
 
Last edited:
As an eBay Associate, HardForum may earn from qualifying purchases.
You have to make sure you get a chip that works in your board. Ideally, you'd get an 865/875 chipset board with 400/533/800 FSB support (likely at a higher price).

A 845 board would only support 400/533 and single channel RAM. I have an Abit IT7-Max2 v2 board (845 chipset) that I still keep around. First board I ever bought. Upgraded it to a P4 3.06Ghz with HT from my original 2.53Ghz chip.
 
ASUS P4P800-E Deluxe or the SE.

If you get one of these boards, be prepared to have to recap it. I've had both a P4P800-SE and still have a P4P800-E Deluxe and both needed a recap (the Deluxe also needed a new RAM slot.)

They use those garbage UCC KZG series caps on the CPU power circuitry.

Get a real Pentium IV - not Prescott as the IPC is lower than Northwood, even with the extra L2 cache.

PressHOT IPC is lower because the pipeline was stupid long, think like 37 stages compared to Northwood at 20. The cache also had a much higher latency, making it useless.

Athlon XP walks all over Pentium IV as far as IPC goes.

While the Athlon XP was more efficient, it couldn't keep up with the Pentium 4's ever increasing clockspeeds. The Athlon XP 3200+ is still slower than the Pentium 4 3.2, which it was marketed to compete with. The Pentium 4 also has SSE2, SSE3 (Prescott) and Hyperthreading which helped in some workloads. If you want to run Steam on an old machine like that (Windows XP is supported till December 31st), you'll need a Pentium 4 because Steam requires SSE2.

The Athlon XP did have an advantage in price though, it was something like half or less the cost of an equivalent Pentium 4.
 
Back
Top