Floppy Drive vs Floppy Cable

PornoSatan

2[H]4U
Joined
Sep 3, 2004
Messages
3,493
Ever connected a floppy drive, and had the light stay on? Ofcourse you have, we all have. What is it an indicator of? The (most likely) floppy cable is backwards, or a (less likely) bad floppy drive.

So here I present Figure A

16.jpg

A standard keyed floppy cable, with the stripe on the right.


Here's figure B

floppytech.jpg

A floppy drive! Notice the keyed groove is at the top.

Now pretend the cable in Figure B wasnt there. Due to these little keyed notches, there's only one way the cable in Fig A. can connect to Fig B. In this case the red stripe would be situated to the right. The result of this?

"It's backwards!" screams the floppy drive.
"No its not!" screams the cable.

I must admit, I think I've tossed a floppy or two based on trusting the cable. Maybe I shouldnt have.




Real story:

Just recently connected a floppy drive and noticed the green light of doom. Checking my connections, everything seemed tip top, the cable as well as the floppy drive itself were keyed, so they only fit one way. "This floppy drive better not be bad" I think to myself. After deciding to test another (keyed) cable, same result. This particular drive/cable combo I had went against what I normally taught myself: "Pin 1 is usually nearest to the power connector". Nevertheless I was tempted to toss it here. But then I remembered I had one more older NON Keyed cable, one of the ones that come with B drive connectors as well. I situated the red stripe near the power connector which in my case was to the left and not above like in Fig B. Lo and behold, it worked. The whole issue was that due to the key notches on the cable and drive connector, the cable only inserted backwards.
 
The cable or the FDD is keyed wrong.

While facing the connector on the cable, with the key on bottom, pin-1 should be on the RIGHT hand side. According to your picture in Figure A, that cable is correct.

Inspecting Figure B, the connector is keyed wrong, since pin1 is usually to the LEFT, when facing the rear of the FDD (opposite of IDE drives; IDE drives have Pin1 on the RIGHT when facing the rear of the drive).
 
Back when I used floppy drives it was easy to remember. Red to Pin 1. HDD's were the same too I believe.
 
What is this "floppy" you speak of?
actually only half joking. The only IDE this in any of my computers is a normally disconnected optical in the server. vilya is SATA only, narya is a SATA laptop drive, and nenya just has the optical...
 
What is this "floppy" you speak of?
actually only half joking. The only IDE this in any of my computers is a normally disconnected optical in the server. vilya is SATA only, narya is a SATA laptop drive, and nenya just has the optical...

there, now its easier to read your post.
 
Back
Top