PornoSatan
2[H]4U
- Joined
- Sep 3, 2004
- Messages
- 3,493
Ever connected a floppy drive, and had the light stay on? Ofcourse you have, we all have. What is it an indicator of? The (most likely) floppy cable is backwards, or a (less likely) bad floppy drive.
So here I present Figure A
A standard keyed floppy cable, with the stripe on the right.
Here's figure B
A floppy drive! Notice the keyed groove is at the top.
Now pretend the cable in Figure B wasnt there. Due to these little keyed notches, there's only one way the cable in Fig A. can connect to Fig B. In this case the red stripe would be situated to the right. The result of this?
"It's backwards!" screams the floppy drive.
"No its not!" screams the cable.
I must admit, I think I've tossed a floppy or two based on trusting the cable. Maybe I shouldnt have.
Real story:
Just recently connected a floppy drive and noticed the green light of doom. Checking my connections, everything seemed tip top, the cable as well as the floppy drive itself were keyed, so they only fit one way. "This floppy drive better not be bad" I think to myself. After deciding to test another (keyed) cable, same result. This particular drive/cable combo I had went against what I normally taught myself: "Pin 1 is usually nearest to the power connector". Nevertheless I was tempted to toss it here. But then I remembered I had one more older NON Keyed cable, one of the ones that come with B drive connectors as well. I situated the red stripe near the power connector which in my case was to the left and not above like in Fig B. Lo and behold, it worked. The whole issue was that due to the key notches on the cable and drive connector, the cable only inserted backwards.
So here I present Figure A
A standard keyed floppy cable, with the stripe on the right.
Here's figure B
A floppy drive! Notice the keyed groove is at the top.
Now pretend the cable in Figure B wasnt there. Due to these little keyed notches, there's only one way the cable in Fig A. can connect to Fig B. In this case the red stripe would be situated to the right. The result of this?
"It's backwards!" screams the floppy drive.
"No its not!" screams the cable.
I must admit, I think I've tossed a floppy or two based on trusting the cable. Maybe I shouldnt have.
Real story:
Just recently connected a floppy drive and noticed the green light of doom. Checking my connections, everything seemed tip top, the cable as well as the floppy drive itself were keyed, so they only fit one way. "This floppy drive better not be bad" I think to myself. After deciding to test another (keyed) cable, same result. This particular drive/cable combo I had went against what I normally taught myself: "Pin 1 is usually nearest to the power connector". Nevertheless I was tempted to toss it here. But then I remembered I had one more older NON Keyed cable, one of the ones that come with B drive connectors as well. I situated the red stripe near the power connector which in my case was to the left and not above like in Fig B. Lo and behold, it worked. The whole issue was that due to the key notches on the cable and drive connector, the cable only inserted backwards.