evga x58 Question/Possible Problem

bosorio

Gawd
2FA
Joined
Sep 1, 2005
Messages
531
So I just upgraded to an i7 finally, and I have a semi-noob question. Im not sure if this is normal, and havnt been able to find a definite answer.

System consists of;
OCZ 700W PSU
evga x58 SLI
i7 930 - stock HSF
Triple Chan. Corsair Dominator DDR3 6GB C7
XFX GTX 260 C216 Black Edition
Lots of Hard drives

Here is the issue;
If I put my memory modules in bank 2, 4, and 6 the mobo wont boot up. It starts up for a few seconds and then shuts down, and repeats. No codes, No beeps.

If I put the modules in bank 1, 3, and 5 everything works perfect.

I did read in the manual that if you're using triple channel configuration with only three modules that you should populate bank 1, 3, and 5 first. But it doesnt explicitly state that this is how you MUST install them.

Ive had very similar problems with memory banks going dead on evga boards in the past so I just want to see if anyone knows if this sounds normal, or do I have an RMA on my hands?

Thanks for any input.
 
If I put my memory modules in bank 2, 4, and 6 the mobo wont boot up. It starts up for a few seconds and then shuts down, and repeats. No codes, No beeps.

If I put the modules in bank 1, 3, and 5 everything works perfect.

I did read in the manual that if you're using triple channel configuration with only three modules that you should populate bank 1, 3, and 5 first. But it doesnt explicitly state that this is how you MUST install them.
The manual implies that you MUST install them that way. So... install them that way. EVGA will not allow you to RMA the board if you are honest with them because they will not believe there is a problem.

Edit: this is normal. Don't worry!
Edit 2: I have an EVGA X58 SLI LE.
 
The manual implies that you MUST install them that way. So... install them that way. EVGA will not allow you to RMA the board if you are honest with them because they will not believe there is a problem.

Edit: this is normal. Don't worry!
Edit 2: I have an EVGA X58 SLI LE.
Ditto (sans the LE).
 
Again, the manual doesnt explicitly say that you have to populate 1,3 and 5 first or the board wont work.
Anyway, I was going to send it back to amazon (and get something else), not evga RMA, but it looks like I dont have to...

Thanks
 
Slot 1, 3, and 5 are primary slots for memory, thats is where you populate using a 6g kit
 
Back
Top