So I just upgraded to an i7 finally, and I have a semi-noob question. Im not sure if this is normal, and havnt been able to find a definite answer.
System consists of;
OCZ 700W PSU
evga x58 SLI
i7 930 - stock HSF
Triple Chan. Corsair Dominator DDR3 6GB C7
XFX GTX 260 C216 Black Edition
Lots of Hard drives
Here is the issue;
If I put my memory modules in bank 2, 4, and 6 the mobo wont boot up. It starts up for a few seconds and then shuts down, and repeats. No codes, No beeps.
If I put the modules in bank 1, 3, and 5 everything works perfect.
I did read in the manual that if you're using triple channel configuration with only three modules that you should populate bank 1, 3, and 5 first. But it doesnt explicitly state that this is how you MUST install them.
Ive had very similar problems with memory banks going dead on evga boards in the past so I just want to see if anyone knows if this sounds normal, or do I have an RMA on my hands?
Thanks for any input.
System consists of;
OCZ 700W PSU
evga x58 SLI
i7 930 - stock HSF
Triple Chan. Corsair Dominator DDR3 6GB C7
XFX GTX 260 C216 Black Edition
Lots of Hard drives
Here is the issue;
If I put my memory modules in bank 2, 4, and 6 the mobo wont boot up. It starts up for a few seconds and then shuts down, and repeats. No codes, No beeps.
If I put the modules in bank 1, 3, and 5 everything works perfect.
I did read in the manual that if you're using triple channel configuration with only three modules that you should populate bank 1, 3, and 5 first. But it doesnt explicitly state that this is how you MUST install them.
Ive had very similar problems with memory banks going dead on evga boards in the past so I just want to see if anyone knows if this sounds normal, or do I have an RMA on my hands?
Thanks for any input.