e7200 overclocking. Lower Mult, Higher FSB or Higher Mult, Lower FSB?

CruisD64

2[H]4U
2FA
Joined
Mar 6, 2007
Messages
2,506
So I have an e7200 that I've been tweaking every so often to get maximum performance. I have it stable at 3.8 with 1.352 volts (10 passes IBT). That is with 9.5x400. What is the benefit of lowering multiplier and raising fsb? Is it possible to get more out of the chip? I have an asus maximus and i know that it will do well past 500 fsb. Is it possible that a configuration like 444x9 would be possible? I've tried 421x9.5 to hit 4ghz but my temps get to like 73c in IBT and it fails. Voltage is 1.425 which is higher than i'd like. So what should I do? I run my northbridge voltage at 1.4v, memory at 2.1v. Everything else is set at auto. Thanks!
 
I'm in a similar boat here. I'm currently running my E7200 @ 3.9Ghz but doing so with 1.4125v. I can POST at 4Ghz but there is no stability in Vista. At the end of the day max clockspeed is king. Mostly because the FSB difference is small. At the end of the day 421x9.5 is not substantially different from 444x9. Heck even 500x8. So sure run the FSB as high as you can but don't sacrifice a lot of total clockspeed for it. So while 500x8 is "better" than 400x10. I'd take say 425x9.5 over 500x8
 
It's better to use a lower FSB speed and higher multiplier in general since you will put less strain on the northbridge. The difference in performance between using a high FSB and low multiplier versus a low FSB and high multiplier is effectively negligible.
 
Is DDR2-1066 required to get to 3.8GHz+ with a 7200 cpu, or would DDR2-800 be fine?
 
Back
Top