Dual 2.5" > single 3.5" bay

I think a lot of people prefer actual bay adapters than brackets... Just 'cuz it's a lil' more robust.I think I've seen those on Newegg as well anyway. Personally I wanted to put my SSD into a 5.25" bay, so I found a nice Lian-Li 2.5" to 5.25" bay adapter that will hold up to two 2.5" drives. I saw other plastic adapters that held up to three 2.5" drives but they cost more, looked cheaper, and I had no need for a third 2.5" slot.

My rationale for putting my SSD in a 5.25" bay comes from my case layout, the front 120mm fan is attached to the 3.5" HDD bay (not the case), and that bay can be slid up or down the 5.25" bays... Since my sole 3.5" HDD sits decoupled on a slab of foam at the bottom of the case, I figured I'd slide in the SSD above it, and I'd move up the HDD bay (and the fan) several slots so that the fan actually points (unobstructed by drives) at the top/center of the case (CPU/top of GPU) rather than the bottom (dead space). I guess I should just take a picture, be much simpler... :p
 
This is the adapter I was referring to in my previous post btw, I only bring it up because I had somewhat of a tough time finding 2.5" to 5.25" adapters... 'Specially one under $10 (this one barely manages that). I saw a lot of awful plastic ones for $15 and whatnot, seemed kinda silly.
 
These are nice as well, picked up two last week, ship free with Prime.
 
As an Amazon Associate, HardForum may earn from qualifying purchases.
Back
Top