DFI Nforce 4 problems solved here.......

Tripp17

Gawd
Joined
Jan 15, 2005
Messages
564
Ok, alot of people are having problems with there DFI nforce4 boards and i know of a problem alot of people have and dont know it. Here is the problem:

Some PSUs have thicker than normal wires, like the X-connect psu or the OCZ mod stream.....as a result of this, when some people are plugging in the 12v 4-pin wire to the connector, they are accidently bending the resistor thats right next to the 12v 4-pin connector. If this gets bent as a result of the wire being too thick, it will cause instability or make a system not post at all. A great indication that this is the problem is by looking at the red led lights in the left hand corner. if 3 of 4 are lit and you arent getting a post, only beeps, this is your problem. Others have just stability problems as a result. I have already helped 4 people with this problem and they didnt even know that this was there problem. Most dont and end up blamming there memory or PSUs or the CPU, ect. So , if you have a premodded PSU or modded it yourself, or even if your wires are thicker than norm and you are having stablity problems or no post at all, there is a good chance this is your problem. I had this problem and i shaved the rubber grip down to normal size on my Ultra X-connect PSU 12v 4-pin wire and bent the resistor back into place, and never had a problem again. After i helped the 4th person, i had to post this as im sure there are others who have no clue why there DFI Nforce4 system isnt working or is unstable. Good luck.
 
I have the OCZ Modstream 450W and the DFI nf4 Ultra, and I had no problem plugging in anything. I was very careful, to say the least, I mean extra careful. If everyone is careful, nobody should bend any pins.
 
jabronidan said:
I have the OCZ Modstream 450W and the DFI nf4 Ultra, and I had no problem plugging in anything. I was very careful, to say the least, I mean extra careful. If everyone is careful, nobody should bend any pins.

Yes, with the mod stream you are correct.....however.....with the Ultra X-Connect, the wires are even thicker and pose even more danger to the resistor by bending it. The problem is, at least with the ultra, is there is NO way to get the 12V 4-pin powercord in without bending that resistor due to how thick the base of the cords are......OCZ arent nearly as bad, but can still pose a threat. It doesnt matter how careful you are with an Ultra, its just too big. And there are other PSUs as well that have this problem. And then people go around blaming there memory or cpu, when in fact the problem is the PSU's wires.
 
Just wanted to let people know that countless people have IM me and told me that this was there problem, and thanked me. If you have a DFI Nforce4 board and are having stability issues OR cant post, this may very well be the problem.
 
so it is on ocz powerstream or modstream? i saw both and was just wondering because you said "premodded" psu's. thanks a lot dude.
 
Back
Top