Ok, alot of people are having problems with there DFI nforce4 boards and i know of a problem alot of people have and dont know it. Here is the problem:
Some PSUs have thicker than normal wires, like the X-connect psu or the OCZ mod stream.....as a result of this, when some people are plugging in the 12v 4-pin wire to the connector, they are accidently bending the resistor thats right next to the 12v 4-pin connector. If this gets bent as a result of the wire being too thick, it will cause instability or make a system not post at all. A great indication that this is the problem is by looking at the red led lights in the left hand corner. if 3 of 4 are lit and you arent getting a post, only beeps, this is your problem. Others have just stability problems as a result. I have already helped 4 people with this problem and they didnt even know that this was there problem. Most dont and end up blamming there memory or PSUs or the CPU, ect. So , if you have a premodded PSU or modded it yourself, or even if your wires are thicker than norm and you are having stablity problems or no post at all, there is a good chance this is your problem. I had this problem and i shaved the rubber grip down to normal size on my Ultra X-connect PSU 12v 4-pin wire and bent the resistor back into place, and never had a problem again. After i helped the 4th person, i had to post this as im sure there are others who have no clue why there DFI Nforce4 system isnt working or is unstable. Good luck.
Some PSUs have thicker than normal wires, like the X-connect psu or the OCZ mod stream.....as a result of this, when some people are plugging in the 12v 4-pin wire to the connector, they are accidently bending the resistor thats right next to the 12v 4-pin connector. If this gets bent as a result of the wire being too thick, it will cause instability or make a system not post at all. A great indication that this is the problem is by looking at the red led lights in the left hand corner. if 3 of 4 are lit and you arent getting a post, only beeps, this is your problem. Others have just stability problems as a result. I have already helped 4 people with this problem and they didnt even know that this was there problem. Most dont and end up blamming there memory or PSUs or the CPU, ect. So , if you have a premodded PSU or modded it yourself, or even if your wires are thicker than norm and you are having stablity problems or no post at all, there is a good chance this is your problem. I had this problem and i shaved the rubber grip down to normal size on my Ultra X-connect PSU 12v 4-pin wire and bent the resistor back into place, and never had a problem again. After i helped the 4th person, i had to post this as im sure there are others who have no clue why there DFI Nforce4 system isnt working or is unstable. Good luck.